Make sure you aren't leaking coolant into the crankcase. The engine will not start while there is moisture inside the distributor cap. Perhaps it was sprayed when you cleaned the engine, perhaps the car ran through some deep standing water and splashed the distributor... in any case, it must be completely dried out before the engine will start and if there is moisture in the crankcase it will condense to the inside of the distributor cap.
Moisture under the distributor cap from Windy D
Ignition control module.. located under the distributor The distributor cap is probably cracked and moisture is getting into it. Replace the cap .
More than likely you have a crack in your distributor cap or moisture is penetrating your ignition somehow. Also could be your module which is bolted/screwed to the very bottom of the distributor, under the cap not literally under it.
In the distributor, under the rotor.In the distributor, under the rotor.
It is inside the distributor, under the cap and rotor.It is inside the distributor, under the cap and rotor.
It is the sensor in the distributor under the cap and rotor.It is the sensor in the distributor under the cap and rotor.
buy a new distributor
The distributor pick up plate is under the rotor inside the distributor.
The "crank" sensor is the pickup plate under the distributor cap.The "crank" sensor is the pickup plate under the distributor cap.
Under the rotor inside the distributor capUnder the rotor inside the distributor cap
One of many things. moisture under it, dead rotor, dead coil, bad wires, For moistue a little wd 40 may fix it
It is directly under the rotor inside the distributor cap.It is directly under the rotor inside the distributor cap.