Jeep Cherokee

Where is the distributor pickup located on a 1990 jeep Cherokee with a 4.0?

123

Top Answer
User Avatar
Wiki User
Answered
2014-12-21 13:10:01
2014-12-21 13:10:01

The distributor pick up plate is under the rotor inside the distributor.

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


hey are located inside the distributor and function as the trigger for the ignition system to produce spark. The pickup coil monitors the rotation


it's underneath the rotor in the distributor. you have to take the distributor out to change it.


No crank sensor on a 1990, only the pickup plate (cam sensor) in the distributor. how about a 1991?





its located right on the top of the motor by the compreesor


It is located on the back side of the engine, where the distributor originally went.


its inside the distributor cap should have two-three plugs going to it, it is about the same size as a domino(black).


Typical: Remove distributor. Use punch to tap roll pin from gear at base of distributor. Use an arbor press (not a hammer) to press distributor mainshaft out of gear. Shaft will then easily come free of the distributor. If a hammer is used, now replace the complete distributor. Unbolt the pickup and replace. Reinstall shaft and gear being sure that gear hole aligns with shaft hole. Install a new roll pin. Install in vehicle. Set ignition timing.


The circuit breaker for the headlights of a 1990 Jeep Cherokee Laredo is built into the headlight switch. If the circuit is overloaded it will act the same as if it had a short in it.


it is located on the drivers side of the engine under the air intake manifold


The 1990 Jeep Cherokee electric fan relay switch is located on the firewall in the engine compartment. The fan relay switch will be on the passenger side of the firewall.


being a 1990 it may have a distributorles ign, find one of the spark plugs,and follow one of the wires back to the end. if it goes to a small black box, then it is a distributorles. There is no distributor. It has coil packs located underneath the front exhaust manifold.



its under the distributor cap. its black and is held to the distributor with 4 Phillips screws. there are 2 studs for the control wires.


Chevrolet s10 v6 2.8 liter pickup timing degree, how to set the degree


Need to replace the ingintion module in the distributor. You will see a electrical connector on the right side of the distributor, those wires plug into the module. Just remove the dist. cap and rotor and you will see it.



the EGR valve is just under the distributor cap


The only speed sensor on the engine is inside the distributor.


on the base of the distributor,look at it and you'll see the wires plugged in,thats it.


I need to change the fuse on the horn and hazzard lights on 1990 toyota pickup, what amp should I use?


it should be on the frame rail just below the driver door


Look in a removable housing at the engine end of the upper radiator hose



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.