answersLogoWhite

0

it's underneath the rotor in the distributor. you have to take the distributor out to change it.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Where is the ignition control module 1997 Chevy cavalier 2.2 L?

where is the ignition control module loacted on a 1997 chevy cavalier


How do you change the ignition control module in a 1988 Chevy Silverado 5.7 L?

How do you change the ignition control module in a 1988 Chevy Silverado 5.7L


Where is the ignition control module located an a 1983 Chevy blazer?

Where is the control module located on the 1983 Chevy blazer


Where is the ignition module on a 1999 4 cylinder Chevy S 10?

The 1999 Chevy S 10 pickup truck ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.


Where is the ignition control module located on a 1998 Chevy s10 pickup with a 2.2l engine?

Lower passenger side of engine block, the coils are attached to it.


How do you change the Ignition Control Module in a 1995 Blazer S-10?

Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.


Where is the ignition and distributor located on a 1990 Chevy Celebrity?

The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.


Where is a ignition control module a 1987 Chevy blazer s10?

The ignition module is located in the distributor, under the distributor cap.


Where is the 1988 Chevy engine control module?

In a 1988 Chevy pickup the ECM is located behind the glovebox.


Where is the ignition control module located on a 1992 Chevy S-10 Pickup?

The Distributer module on "92" S-10 Vin code "W" or "Z" is located on the distributer,you must remove the distributer cap to gain access to the ignition module. Once you have gained access to the ignition rotor it is always necessary to always test the module before replacing it.


How do you change the ignition control module in a 1989 Chevy Celebrity?

Which engine does your car have?


What would cause a 1993 Chevy pickup with a 350 to lose spark?

The ignition module that is in the distributor is probley bad.