0
What else can I help you with?
Is it possible to convert abs to standard hydraulic brakes on a 1990 Jeep Laredo?
Yes, replace the brake booster and master cylinder.Yes, replace the brake booster and master cylinder.
Do you have to replace the master cylider if the slave cylinder has been replaced in a 1993 Saturn?
The Slave Cylinder and the Master Cylinder control totally different systems. The Slave has to do with the clutch, and the Master has to do with the brakes. They have nothing in common.
What would cause the brakes to go out on a 91 jeep Cherokee with abs there are no leaks in the lines.?
Failed Master Cylinder would be my guess. Replace the Master Cylinder.
How do you repair the brakes on a 1992 Chrysler lebaron?
be more specific.. replace pads..?? replace hose..?? repair master cylinder..??
What causes the brakes to give when i push the brakes the pedal slowly goes down after a few seconds?
Master Cylinder seals are defective. Replace the Master Cylinder ASAP. Stop driving the vehicle until you have this repaired. The brakes can fail completely at any moment.
Why wont the Brakes bleed 1993 Mercury Sable?
did you replace the master cylinder if so it has to be bleed frist
What is the reason of when you apply brakes the brake pedal goes down?
If sitting still in your car with the engine running you can apply the brakes and the pedal slowly goes towards the floor you have a defective brake master cylinder. The only repair is to replace the master cylinder. This is a very dangerous situation and must be repaired immediately. Failure to replace the master cylinder may result in an accident.
How do you convert anti-lock brakes to regular brakes on a 1990 Lincoln Mark VII?
you need to take off the master cylinder and the accumulator and replace it with a master cylinder from a non antilock vehicle like a thunderbird or cougar from about 1985 to 1988.
Brake pedal goes to floor sometimes but still have brakes no visable leaks?
Master Cylinder internal seals are failing. Replace the Master Cylinder before you have an accident when it fails permanently.
How do you replace a master cylinder on a 1992 Chevy Lumina?
Replacving a master cylinder is usually pretty straight forward. Remove the brake lines, unbolt/remove the master cylinder, Re-install in reverse order. The hard part is bleeding the new master cylinder/brakes once you put it on. Caution: Your life depends on your brakes. If you're not sure you can do it right... don't. Get someone to help you.
Driving along brake pedal went all the way to floor and ABS light came on How do you repair brakes on a 1997 dodge ram 1500?
Defective Master Cylinder or broken brake line. Replace the master cylinder and bleed the brakes.
When you first push brake pedal down it goes straight to the floorI need to pump brakes several times to get it to resume normal pressure 2003 silverado?
First thing I would do is check the fluid level in the Master Cylinder, and bleed the brakes. Start at RR, then LR, RF, and end up at LF, making sure you keep the Master Cylinder full at all times. If that does not help, replace the Master Cylinder.First thing I would do is check the fluid level in the Master Cylinder, and bleed the brakes. Start at RR, then LR, RF, and end up at LF, making sure you keep the Master Cylinder full at all times. If that does not help, replace the Master Cylinder.
