lose of vacuum to heater deverter valve.follow heater hoses from engine to heater core valve has two hoses in and two hoses out and one vacuum hose.vacuum hose gose to tee then back to engine other vacuum from tee controls heater switch defrost to floor heat knob. replace all of these lines about 6 feet will do it.now the bad, you must pull back the dog house about a foot divers side to remove one vacuum hose just do it the first time and both problems should go away.
Is anyone on line to help me with this question? Where is the fast idle thermal valve in a 1997 Chevy astro van located?
vacuum leak, bad idle control sensor
There are a few things that could cause an 87 Chevy Astro to idle high when it is started and warmed up. It could be a bad fuse, a leak in the vacuum, or an issue with the throttle.
You can adjust the idle from the throttle body. Replacing the throttle body might have accidentally change the idle speed. The idle speed adjustment screw can be turned either way to raise or lower the idle.
The idle speed is computer controlled on a LT1 engine. If it is a little high, try checking for vacuum leaks.
If you are talking about the air idle control valve it is a little square black box with two bolts and a plug on top of your engine block.
inspect the distributor gear.
Idle is set by the computer.
For non fuel injected models, on the side of the carburetor there is an idle screw. Turning the screw slightly will raise the idle on your Chevy truck.
Where is the idle speed motor located at on a 1995 chevy blazer?
carborator
The IDLE is controlled by the computer. THERE IS NO ADJUSTMENT.