answersLogoWhite

0

The stud can be replaced. If you go to NAPA auto parts and order a "P19" stud kit, it will fit in and replace your broken stud.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

I have a 96 explorer with po756. I replaced the shift solenoid but did not fix. What else could be wrong?

If you replaced the correct shift solenoid (SS B), check for a broken band in the trans.


What if the fuel pressure is at 80 psi in an explorer?

Your pressure gauge may be broken....If it fluctuates, then you know its not your gauge, but if your gauge always reads 80, it may need to be replaced.


How to Open hood with a broken cable on 1994 Ford Explorer?

how to open hood with a broken cable on a 1994 ford explorer


how to fix broken concrete drive way be repaired or does it have to be replaced?

how to fix broken concrete drive way be repaired or does it have to be replaced?


Why would a 94 explorer have a bad vibration in the front when you are driving between 55 and 70?

There could be a belt broken in one of the tires. The rotors may also need turned or even replaced.


How do you repair an exterior door handle on a 1994 Ford Explorer?

you first need to remove the door panel so you can see what is brocken which is done by moving the door handle up and down while looking at the moving parts insid the door. it could be a broken clip which attaches to the latch


How do you fix a diverter spout lever that broke off?

Depending where is has broken off, depends to what extent of how much you will have to replace, but worse case scenario is, inside there is a cartridge that has a little lever that the diverter handle attaches too. This whole cartridge needs to be replaced. Depending on the make, it can be costly.


Can a club be replaced in your golf bag if broken in anger and you only have thirteen clubs in bag?

No. A club can only be replaced during your round if broken while playing a shot.


Your 2001 explorer is swaying front end?

sway bar is broken


Why heat blower does not work 96 ford explorer?

Because its broken


Your high beams switch is broken in your 2001 Honda accord how can you fix it?

If the high beam switch is broken that it should be replaced. When the unit is replaced the high beams will work again.


How do you release a broken latch with a broken cable on a 1988 Ford Explorer?

use the gas tank to masturbate and ejaculate in the engine