get a flat head screwdriver put it in the hole turn 2 the left thn turn 2 the right
Hi,I assume that the bonnet is the same as the Connect and Focus?If it is, there is a lock on the bonnet/hood. Either behind the badge or the flip up panel
key middle grill then left and right
Under steering wheel right hnd side
There is a keyhole hidden behind the Ford logo in the grille Take the transit door key come to the front of the van and look at grill under the bonnet their you will find a place where this key can be inserted and turn this realises the lock and the bonnet will pop open.
turn ignition key in lock on front grille
The bonnet is opened by the key,there is a rubber cover in the grille,turn key 1 way to release then the other way to open.
To open a Ford Transit bonnet without a key, locate the release lever inside the vehicle, usually found near the driver's side footwell. If that doesn't work, you may need to access the bonnet latch from underneath the vehicle by using a flat tool to manipulate the latch mechanism. Alternatively, you can consult a professional locksmith or mechanic for assistance to avoid damaging the vehicle. Always ensure you have the right to access the vehicle before attempting any method.
My Ford Connect bonnet is opened by the main ignition key. There is a sliding plastic cover at the front center below the grill. Insert key and turn to the right, bonnet will click to safe open. Turn key again and at the same time lift bonnet. Remember to remove the key.
To open the bonnet of a Ford Tourneo Connect, first, locate the bonnet release lever inside the vehicle, typically found on the driver's side near the footwell. Pull the lever to release the initial latch. Then, move to the front of the vehicle, slide the safety catch (usually located under the centre of the bonnet) to the side, and lift the bonnet open. Use the prop rod, if available, to secure the bonnet in an upright position.
all you can do is drill it out and use a grinder as well takes around a hour to do big job
Open your fuse box, there is a post three marked with a symbol for the lid, you will need to connect the hot side of a jumper cable to it and the ground to the door striker. connect the other end to a battery and use the swith to open th lid. Right out of the owners manula
open the bonnet (hood) and look to the left hand side of the engine towards the back by the bulkhead.