depends on what year.. if it is a TPI motor.. then there is the VATS system.. with the VATS system.. you need the correct key to start the vehicle.. or it will not start at all.. no matter what method you use..
How do you reset the anti theft on a 96 pontiac grand am? Ok, please follow this very closely. Turn the key on to the on position. Just far enough as to not start your car. You will see anti-theft system flashing. Let it flash for about 10 min. When it quits flashing, remove the key and let it set for about a minute or two. Put the key in the ignitiion and attempt to start. It should work. This worked for me.
i replaced the fuel pump and now my theft system wont work
The factory system is not one "box". The engine computer and body computer work together to provide the theft alarm functions.
It's done with the "Transponder Key", it has a code that is used to unlock the anti theft. If you have a second key, try it. If you don't, the dealer will reset the system to work with a different key.
If the theft light is on in your vehicle, it usually means there is an issue with the anti-theft system. To turn it off, you may need to reset the system by locking and unlocking the car with the key fob or key. If this doesn't work, you may need to have the system diagnosed and repaired by a professional.
To disable the anti-theft system on a 1995 Ford E-150, you typically need to locate the anti-theft module, which is often found near the steering column or under the dashboard. Disconnecting the battery for a few minutes can sometimes reset the system. If that doesn't work, consulting the vehicle's service manual for specific instructions or seeking help from a professional locksmith or mechanic may be necessary. Always remember to check local laws regarding anti-theft systems before making modifications.
To disable the theft system on a 1998 Pontiac Grand Am, you can try using the key in the driver's door to unlock it, as this can sometimes reset the system. If that doesn't work, you can disconnect the battery for about 10-15 minutes and reconnect it to reset the system. If the problem persists, it may be necessary to consult a professional or refer to the vehicle's service manual for further troubleshooting.
it is the anti theft. lock all the doors the unlock the door with the key. try with passenger door too. if this does not work it is some other problem with your anti theft system.
To reset or disable the anti-theft system on a 1997 Isuzu Trooper, start by using your key to unlock the driver's door, as this can sometimes reset the system. If that doesn't work, disconnect the vehicle's battery for about 10-15 minutes, then reconnect it; this can also reset the system. To enable the anti-theft system again, simply lock the vehicle with the key or remote. If issues persist, consulting the owner's manual or a professional mechanic may be necessary.
To remove or bypass the ignition anti-theft system on a 2003 Mitsubishi Galant, you would typically need to reprogram or replace the key with a transponder chip that matches the vehicle's system. Alternatively, disconnecting the battery for a short period may reset the system, but this isn't guaranteed to work. It’s advisable to consult the vehicle’s manual or seek assistance from a professional locksmith or mechanic, as tampering with the anti-theft system can lead to further issues or void warranties.
There is no way to bypass the anti-theft system in the cadillacs. The keys are encoded with a special chip. Without that chip, the car will If the chip has any major or severe cuts or damage, it too can cause the car to activate the anti-theft. In order to resume use of your cadillac, you must wait a time length of 15 mins - to almost 1 hr. Usually if the anti-theft is on, the display countsdown the time you will have to wait before you can restart the vehicle. If this doesn't work, your car will require service from the dealership.
Just reset the radio presets and clock. If the radio has an anti-theft system you will need the code to get the radio to work again.