Ball Joint Replacement: I used the rental tool to press out the old ball joint and press in the new one. When pressing out the old ball joint the key is to properly set up the press, tighten the screw on the press, then give the screw a few good solid blows to shock the old ball joint. Once I did this the old ball joint pressed out almost effortlessly. Installation of the new ball joint was a breeze. The only comment is be extremely careful not to damage the axle boot seals. Have wire on hand to tie the spindle assembly and axle for support to prevent damage to the brake hoses and ABS system.
go to strutmasters.com
How do you replace the ignition switch on a 2000 ford expedition?
Drain and remove the fuel tank to gain access to the pump.
Where is the airbag module on the 2000. Ford expedition
I believe the lower balljoints can be changed , but the upper control arm assembly with the balljoint has to be changed
I paid 200 for a mechanic to replace it. I had to replace 3 coils in the last 3 years. I have a 2001 expedition
Type your answer here... how do you replace the shift cable on a 2000 expedition 5.4 liter
When you replace your oil filter it come with a new gasket. Just make sure when you remove / replace the old oil filter the oil gasket comes out with it.
You need to refer to the service manual to remove a 2000 Ford expedition XLTS key-less entry system.
Take the ford to a mechanic !!
Drain the fuel from the fuel tank. Remove the fuel line. Remove the fuel pump retaining plate. Remove the fuel pump retaining bolts. Reverse the process to install the new fuel pump.
How can I replace the headlamp on a 2000 Saturn SL1