0
open the hatch and pull the carpet lining rear of the the trunk (by the latch) area back and you should see several winged nuts. unscrew them and the rear lights just pull right out. i think there's 5 but not sure, just make sure you get the ones in the corner. to get the carpet up you have to remove the little flap that folds over the t-top storage area and the plastic over the rear wheels, this is really easy though you just turn the little locks with a quarter and they come right out.
What else can I help you with?
How do you replace a brake light swith on a 1995 LeBaron?
Its located on the brake pedal. Unplug the wiring harness and unbolt it and replace it.
Replace brake replace brake light 1995 blazer?
Your brake light is probably brake fluid low or emergency brake on. Rear brake lights are replaced by removing the lens and replacing the dual filament bulb.
How do you replace brake light switch on a Chevy Tahoe?
How do you replace a break light switch on 1995 Chevy Tahoe
How do you change rear brake pads on a 1995 Firebird Trans Am?
Lift the car, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Put in the new brake pad, replace the brake shoe/caliper, replace the tire, and lower the car.
What is making your brake light stay on in a 1995 Delta 88?
replace the sensor behind brake paddle.
How do you replace third brake light bulbs in 1995 Nissan Pathfiner?
the screws come off and you replace it
How do you replace a brake switch on 1995 Pontiac Firebird?
To replace the brake switch on a 1995 Pontiac Firebird, first disconnect the negative battery cable to ensure safety. Locate the brake switch, which is typically mounted above the brake pedal. Remove the electrical connector and the mounting screws to detach the old switch, then install the new switch in reverse order, ensuring it is properly aligned with the brake pedal. Finally, reconnect the battery and test the brake lights to ensure the new switch is functioning correctly.
How do you replace a brake light switch on a 1995 Jimmy?
Located at the upper end of the brake pedal under dash area
How do you replace brake light on a 1995 Toyota Tercel?
To replace the brake light on a 1995 Toyota Tercel, first, open the trunk and remove the plastic cover or trim panel on the side where the brake light is located. Then, unscrew the brake light assembly, disconnect the wiring harness, and remove the old bulb by twisting it counterclockwise. Insert the new bulb, reconnect the wiring, reassemble the brake light housing, and finally test the new light to ensure it’s working properly.
Why does your 1995 Chrysler New Yorker Third Brake Light not work?
Bulb is probably defective. Replace it.
How do you replace the flasher on your Pontiac Firebird 1995?
Pull out the old flasher (located under dash pannel above brake pedal, above the horn relay) and put in the new flasher.
How do you change a brake light in a 1995 Toyota Camry?
Remove the tail light from the outside. Pulls out. Replace bulb. There is no access from the inside of the trunk.
