You have to pull out the seek and scan tabs, I believe. One being hour and vice versa.
Push the set button then use the seek and scan buttons on the radio
To set the clock on a 1989 Cadillac Brougham, first turn the ignition to the "On" position. Locate the clock setting button, usually found on the dashboard or near the radio. Press and hold the "H" button to set the hour, and use the "M" button to adjust the minutes. Release the buttons once the desired time is displayed.
yes front coil springs with front shocks on a 1987 cadillac brougham rear wheel drive
yes
\sff
Turn the ignition to run. On the radio controls, PULL the scan button out to set the hour. Once the the hour is correct, PULL the seek button out to set the minutes.
20
To set the clock press the set button then 1 time on the vol. or the ch. knob. then you will see the clock flash. turn the vol/ch. knob to the correct time. press it again for min. press set and you are done. I dont remember if the radio needs to be on or off. I think off but not sure.
where is the starter to begin with
Not without modification
in the lamp assy. Mercury switch
4" round in front and 6x9 in back