Push the set button then use the seek and scan buttons on the radio
Turn the ignition to run. On the radio controls, PULL the scan button out to set the hour. Once the the hour is correct, PULL the seek button out to set the minutes.
To set the clock on a 1989 Cadillac Brougham, first turn the ignition to the "On" position. Locate the clock setting button, usually found on the dashboard or near the radio. Press and hold the "H" button to set the hour, and use the "M" button to adjust the minutes. Release the buttons once the desired time is displayed.
You have to pull out the seek and scan tabs, I believe. One being hour and vice versa.
To set the clock in a 1991 Dodge Stealth ES, first, turn on the car's ignition. Press and hold the "Clock" button until the display starts flashing. Use the "Hour" and "Minute" buttons to set the correct time, then press the "Clock" button again to save your settings. The clock should now display the updated time.
Turn on the power knob for the radio/clock. Wait until the clock display shows up. Press "set", and use the "scan" and "seek" buttons to set the time. Hope this helps!
The climate control computer may be defective. Check all fuses. is the defrost cold air?
To remove the radio from a 1986 Cadillac Fleetwood Brougham, first disconnect the negative battery terminal to ensure safety. Then, remove the trim panel surrounding the radio using a trim removal tool or flathead screwdriver. Once the trim is off, unscrew the mounting screws holding the radio in place, gently pull the radio out, and disconnect the wiring harness and antenna cable from the back. Finally, set the radio aside for replacement or repair.
If its like my '90, power off the radio so that the time displays. Then, hit Set. Then the Seek/Scan buttons will change the hours and minutes. When you are finished, hit Set again to get out of Clock Setting mode.
hit set button then the sel button and turn the tuner knob
SETTING THE CLOCK (CASSETTE PLAYER) Have the radio on , then TO SET HOUR: Push " SET " and within 5 seconds , PUSH SCAN . Hold it until clock gets to correct hour , then let go . TO SET MINUTES: Push " SET " and within 5 seconds , PUSH SEEK . Hold it in until clock gets to correct minute , then let go . SETTING THE CLOCK ( CD PLAYER ) Push " SET " and with in 5 seconds , PUSH SEEK . Hold it in until the clock gets to the correct hour , then let go . TO SET MINUTES: Push " SET " and within 5 seconds , PUSH SCAN . Hold it in until clock gets to the correct minute , then let go . YOUR CLOCK IS SET
power of the radio with the car on or on switch then press "Set" button next use the tune and volume buttons for hour and minute
the clock is set for time