0
What else can I help you with?
How do you change the front rotors on a 1999 Ford Explorer Is the grease cap threaded?
nope grease cap is not threaded, can usually remove it with a big set of channel locks
Do i put dielectric grease on cap and rotor?
Yes, you can apply dielectric grease to the cap and rotor contacts to help prevent corrosion and ensure a good electrical connection. However, it's important to use it sparingly to avoid interfering with the electrical flow. Additionally, avoid applying grease directly to the spark plug terminals or ignition coil contacts, as this can hinder performance. Always check your vehicle's specifications for any specific recommendations.
How do you change brake rotors on a 2000 Mitsubishi Montero Sport?
you'll need to pop off the grease cap then remove the snap ring to get the hub off to get the rotor off.
Why would a 1993 Dodge Colt not start when it is wet outside?
you could have a cracked distributor cap Check condition of ignition system including distributor cap, rotor and ignition cables. (You didn’t mention engine size because Colt did have a 1.6L “distributorless” engine….it had an ignition block which could crack causing voltage leakage, especially when moisture is about. It is a block where all the ignition cables meet.) If cap, rotor or cables look suspect, change them. With the cables, buy a tube of dielectric grease and use at both ends of the cables to connect to the cap and the spark plugs. Even if the cables look relatively new and you are reluctant to change them, minimally, buy the grease and grease the ends. It helps keep the moisture out and the voltage “in”.
When replacing the rear drums off a 1994 Plymouth sundance how do you remove the drum from the axle flange?
Remove the grease cap in the wheel center. Then remove the cotter pin, and finally the nut. The brake drum should slide off. Remove the grease cap in the wheel center. Then remove the cotter pin, and finally the nut. The brake drum should slide off.
How grease boat trailer wheels?
On hub dust cap there is a rubber gramet and behind gramet is a zirc fitting for grease gun.
How do you remove grease port on rotary hammer item 69274?
There is a tool with unit that matches two of four holes in grease cap.
How do you grease trailer wheels?
On a light trailer or small boat trailer you remove the bearing cap, pack it with grease and re-fit it.
What order does spark plug wires go in 2000 Mazda 626 V6?
Always check lenght! top three have the longest cords, bottom three go long medium small to reach the Cap at the end. The top three are 1,3,5 and the bottom are 246. When putting the wires in, be sure to use Dielectric Grease! the side of the cap says the firing order when you put the wires in. Hope this helps!
What can cause a pickup to stall out in snow and wet weather?
Sure sounds like ignition to me, Particularily cap,rotor and wires. If replaced were they autozone junk or quality ones? Did you use dielectric grease on them? check underneth hood at dark and watch 4 fire or sparks b careful watch where you place your hands
How do you you install a distributor on a 1998 astro van?
how to install distrutor cap and rotors in a 1998 chevy astror van
How do you remove the brake rotors on a 1998 Ford F-150 4.6 4X4?
# Raise and safely support the vehicle securely on jackstands. # Remove the brake caliper assembly. # Remove the front disc brake caliper anchor plate. # Remove the hub grease cap. # Remove the cotter pin. # Remove the spindle nut. # Remove the front wheel outer bearing retainer washer. # Remove the outer front wheel bearing. # Remove the hub grease cap gasket. # Remove the front disc brake hub and rotor. # Remove the wheel hub grease seal. # Remove the inner front wheel bearing.
