0
The 3 cylinder is not firing in your 2001 Ford Taurus you replaced the spark plug but it is still not firing What else could it be?
Check the codes OBD and see if any other cylinders are not firing, and go from there
your local library may have a manual for free to look at good luck dave
Not only the spark plug wire, but also the ignition coil. That is exactly what caused mine.
Rare, but not impossible: fuel injector.
See "Related Questions" below for more
What else can I help you with?
What does No. 7 cylinder misfire malfunction mean?
It means #7 cylinder is not firing properly. Could be a bad plug or plug wire on that cylinder.
Susuki vitara P0304 code misfire 4 cylinder replaced plugs still misfires?
this could be caused by a fuel problem, not spark. check to see if your getting spark to the plug. ck to see if the injector is firing, and run a compression test on that cylinder
Can car be driven with a code P0303?
P0303, number 3 cylinder is miss-firing. You could drive it but depending on the reason why it is miss-firing, it may damage the catalytic converter.
Why would there be back firing in a 1996 Oldsmobile Ciera after the fuel pump has been replaced?
Could be as simple as fouled spark plugs.
What does it mean if a 2000 Honda CR-V has a dead cylinder?
usually it means that a cylinder is not firing. have a compression test done. it could also be a burt valve or a hole in the piston though that is not likely the case. dead cylinder, no spark.
Q Could someone tell you firing order for ford boss v8 and ford 6-cylinder not ecotech thanks?
I will provide the answer once you tell me which engines you are referring to. What Boss V8? What 6 cylinder? Inline or V6? List the exact engine size and I will provide firing orders.
Why does one cylinder missfires on your Kia Optima 2002?
It is probably an ignition problem. Check the mis-firing cylinder's ignition cable from the distributor to the spark plug. A quick check would be to replace the ignition cable on the mis-firing cylinder with one from a firing cylinder. That can rule out the cable. You could have also have a broken or fouled plug. or a bad distributor cap. Carbon tracks inside or on the outside of the cap can allow the spark to jump to ground. If it isn't that, then you have a collapsed lifter or something more expensive.
Cylinder 7 not firing on 98 350 mercruiser what could it be?
It will be a bad cap, bad plug wire or bad spark plug See more at sterndrives.com
2001 Daewoo Leganza engine misfire I replaced plugs wires coil The first time I used the old coil and cylinder 3 misfired Replaced coil and now cylinder 2 is misfiring only happens going over 70mph?
It could be a hairline crack in the head gasket between cylinder 2 & 3.
What is the firing order for a Jeep YJ?
number 1 it could be different in each engine for the inline six engineit is 153624 and in the 4 cylinder engine it is 1342
Why does your 1994 Ford Taurus not start or click or anything replaced battery starter ignition switch?
Maybe you have a problem in your main wiring harness. No fun.. Could also be an electrical sensor.
What else could be wrong besides cylinder 1 ignition coil when the service engine light codes indicate cylinder 1 misfire and Knock?
I had the same problem and went ahead and replaced cylinder 1 coil and all the spark plugs and it worked.
