0
What else can I help you with?
How do you find out which wheel bearing is bad on a 2001 Pontiac grand am gt?
how do you find out if wheel bearing is bad on a 2001 grand am gt
What is the torque spec for wheel bearing on 2003 Pontiac aztek?
192foot pounds
Wheel bearing torque specs 2003 Toyota Corolla?
216 nm
What is the torgue spec for a 2003 Chevy s10 4x4 wheel bearing?
The torque specs for a 2003 Chevy S10 4x4 wheel bearing is 28 ft. lbs. This is equal to 38 N.m.
2003 cavalier torque specs for front wheel bearing?
Wheel bearing hubs on all vehicles has to be at least 200 foot pounds. This should be in the directions when you purchase the wheel hub
What is torque spec for wheel bearing nut on 2003 gmc sonoma?
The torque specification for the wheel bearing nut on a 2003 GMC Sonoma is typically around 50 to 70 ft-lbs. It's important to follow the manufacturer's guidelines and use a torque wrench for accuracy. Always refer to the vehicle's service manual for the most precise specifications and procedures.
What is the lug nut torque for a Pontiac grand am?
wheel lug nuts 100 ft lbs according to our Haynes Manual for a 2003 Grand Am page 1-2 under torque specifications
What are the torque specs on a 2003 Malibu hub bearing?
The 2003 Malibu hub bearing torque specifications are 40 pounds per square inch. You can ruin the bearing by tightening it too much.
How do you change front wheel bearing in 2003 Kia Sorento?
how do i change front wheel bearing of kia sorento 2003
What is the torque spec for the rear wheel bearing bolts of a 2003 Toyota Corolla?
The torque specification for the rear wheel bearing bolts on a 2003 Toyota Corolla is typically around 77 ft-lbs (104 Nm). It's essential to use a torque wrench to ensure proper tightening, as over-torquing can lead to component failure. Always refer to the vehicle's service manual for the most accurate and specific information.
How do you replace front wheel bearings on 2003 Chevrolet Sierra?
Remove the tire and wheel from your 2003 Chevrolet. Remove the axle end cap. Remove the wheel bearing nut. Remove the wheel bearing in the wheel seal. Reverse the process to install the new wheel bearing.
2003 Hyundai elantra wheel bearing retaining nut torque specifications?
found the anwer on Hyundai (www.hmaservice.com) Torque for the Castle Nut:NM(kg-m, lb-ft) (2000-2600, 148-192)
