Four steps : 45 ft lbs, 65 ft lbs, 65 ft lbs, 1/4 turn
25 30 fps
45, 65, 65 ftlbs , 1/4 turn
45, 65, 65 ftlbs , 1/4 turn
There is no such car as a Dodge Eagle
The torque specification for the camshaft bolts on a 1994 Dodge Shadow is typically around 20-25 ft-lbs. However, it's always best to consult the vehicle's service manual for the exact specifications and any specific procedures required for your engine. Make sure to use a calibrated torque wrench for accurate measurements.
The head bolt torque for the Dodge 6 cylinder and V-8 engines is 50 ft. lbs. torque. If it is a diesel engine, the torque is 90.4 ft. lbs. Tighten the bolts by working from the center out, and alternating side to side. This prevents warping of the head.
For what part? Installation Torque? (Engine torque production is about 420 lb-ft )stock.
For a 1961 Dodge D100, the torque specifications can vary depending on the specific component. However, a general guideline for the engine cylinder head bolts is around 65-70 ft-lbs. For the main bearing caps, the torque is typically around 75-85 ft-lbs. Always refer to a service manual for the most accurate specifications for your specific vehicle and engine configuration.
100 ft lbs
What torque specs do you need? Also, what size is your motor and manual or auto tranny?
Hi i wannw know the torque specifications of the water pump in a 2003 dodge magnum 4.7l.Thanks,eric.
passenger side