0
What else can I help you with?
Torque specs on a 1989 dodge shadow 2.2 cylinder head?
45, 65, 65 ftlbs , 1/4 turn
Torque specifications on a cylinder head on a 1989 Dodge shadow 2.2?
Four steps : 45 ft lbs, 65 ft lbs, 65 ft lbs, 1/4 turn
What are the torque specs for 1992 dodge shadow?
What torque specs do you need? Also, what size is your motor and manual or auto tranny?
What are the torque specifications to the Thermostat on a 93 Dodge Shadow 2.2?
25 30 fps
Where is the map sensor on 1990 dodge shadow 4 cylinder?
passenger side
1999 Dodge Caravan Cylinder Head Torque Specs?
i need a Cylinder Head Torque Specs for a 1999 dodge caravan 4 cyl 25 ft lbs, 50 ft lbs, 50 ft lbs, quarter turn.
What are the torque specs for a head gasket on a 1994 dodge shadow?
Start in the middle and work outward in a circular pattern. These steps 45 ftlbs, 65 ftlbs, 65 ftlbs, and 90 degree turn.
What is the torque for the head gasket of a '88 dodge shadow and what is the order to tighten the bolts?
For the 1988 Dodge Shadow, the torque specification for the head gasket bolts is typically around 85 ft-lbs (114 Nm). The recommended tightening sequence usually follows a specific pattern, starting from the center bolts and moving outward in a crisscross pattern to ensure even pressure across the gasket. Always refer to a repair manual for the exact specifications and sequence for your specific engine model, as there can be variations.
Where is the transmission pump on a 3.0 93 dodge shadow?
Inside the front of the transmission. The torque converter sits up against it.
What is the bolt pattern for a 1993 Dodge Shadow ES?
5x100 bolt pattern on 40mm backspacing
What is the torque pressure for 1994 dodge shadow cam bolts?
The torque specification for the camshaft bolts on a 1994 Dodge Shadow is typically around 20-25 ft-lbs. However, it's always best to consult the vehicle's service manual for the exact specifications and any specific procedures required for your engine. Make sure to use a calibrated torque wrench for accurate measurements.
What is the torque sequence on a 2002 Dodge Viper with a V-10?
The torque sequence for the cylinder head bolts on a 2002 Dodge Viper with a V-10 engine typically follows a specific pattern to ensure even tightening. Generally, the sequence starts from the center bolts and moves outward in a crisscross pattern. The initial torque specification is often around 20 ft-lbs, followed by a second pass at 40 ft-lbs and a final angle torque of 90 degrees. Always refer to the specific service manual for precise torque values and sequences.
