0
What else can I help you with?
Can a upstream O2 sensor cause misfiring and engine hesitation at low speeds?
what could cause a car to run for 20 minutes and dye and waiting about 5 minutes it will start back up and run for a couple of minutes and then have to wait and it will start back up and go for about 5 minutes and dye again. Chevy cavalier 2004
When does it start to get cold?
After about 30 minutes of not running.
My 2003 cavalier engine rotates but doesn't start?
Your missing spark or fuel.
I have a 1991 Chevy cavalier standard. While driving it I can only go for like 20 minutes then the engine shuts off and I have to wait for it to start again. What might be causing this?
it may be the o2 scensor
How do you know if your timing cahin is bad on a 2002 Cavalier?
When the timing chain is bad on a 2002 Cavalier, the engine could have several symptoms. The engine could run rough, be hard to start, or not run at all.
How does a planes rise?
the blades in the engine start running
If a 92 Cavalier runs fine a while then stops and won't start for ten minutes is it the coil pack?
could be the crank sencor on the side right of the engine block, next to the transmission. IT IS VERY HARD TO REACH AND REPLACE.
What causes the trac off light to come on?
my trac off light comes on in my 2002 cavalier then the car cuts off, but will start back up minutes later then the check engine light will come on and they both stay on
Why does your 1997 Chevy cavalier run bad when it gets wet?
takes 3 times for engine to start
How do you drain a radiator on a 1996 Chevrolet Cavalier?
all you have to do is run water hoes in the hood of your car and start it why the water is running in to it =)
Whats wrong when an 86 ford aerostar keeps trying to start after the engine is running?
Whats wrong when an 86 ford aerostar keeps trying to start after the engine is running?
How do you seafoam your Vehicle step by step?
get your engine hot for 5 minutes, while running slowly pour it down the carb till the engine stops. (using about half a can) wait 10 min, start engine, it will be hard to start. run it at about 1000 rpm for 3 minutes till all black smoke clears. turn off engine, rinse repeat till no longer seeing black smoke
