answersLogoWhite

0

The spark control module on a 1989 Chevrolet model van is located in the distributor. To check its life, one must remove the distributor cap and unplug the center coil wire. Replace with a clean, brand new spark plug, and test the van's ignition.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is the ignition control module locaded on a 1995 Chevy astro van?

under the distributer cap


What could be the problem with a 95 astro van it cranks over but gets no spark electronic control module was replaced no spark?

Check all of your fuses both in the fuse box in the van and under the hood.


How can you tell if your 1987 Chevy van cruise control module is bad?

To determine if your 1987 Chevy van's cruise control module is bad, check for common symptoms such as the cruise control not engaging, disengaging unexpectedly, or not maintaining speed. You can also inspect the module for physical damage or corroded connections. Testing the module with a multimeter for proper voltage and continuity can further confirm its functionality. If necessary, consult a professional mechanic for a thorough diagnosis.


Where is the power control module located in 1998 Chevy venture van?

Under instrument panel on drivers side on the outboard edge


Where is the power control module located in 2001 Chevy venture van?

Hi, The Powertrain Control Module (PCM) is located inside the Air Cleaner Housing Assembly (the box that holds the air cleaner). This is located under the hood, on the driver side of the van. Good Luck


Will replacing an electronic spark control module distributor with a bypassed standard one help an 85 Chevy Van 305 V8 that cranks but will not start?

One needs to look at the module in the distributor (test it)and the ESC system (sensor, module, and harness connection). Replacing the whole ignition system is expensive and much more than swapping style of distributor.


Where is the cruise control module on a 1990 Chevy G20 van and how do you replace it?

The cruise control module on a 1990 Chevy G20 van is typically located under the dashboard on the driver's side, near the steering column. To replace it, first, disconnect the vehicle's battery to prevent any electrical issues. Then, remove the old module by disconnecting the wiring harness and unscrewing it from its mounting location. Install the new module by securing it in place and reconnecting the wiring harness, then reconnect the battery and test the cruise control system.


Where is the fuel relay module on a 1999 Chevy Express van?

need to fix my express van .


Where is the wiper control module on a 2004 Chevy van?

The wiper control module on a 2004 Chevy van is typically located under the dashboard, near the steering column. It may be mounted on the driver's side or behind the instrument panel. For precise access, it is often necessary to remove some panels or components. Always refer to the vehicle's service manual for specific instructions and diagrams.


What is wrong when code P1362 comes up on a 2002 Chevy Venture van?

Possibly one of these"A faulty ignition control moduleLoose or shorted connection at the module


Where is the fuel relay module located on a 1999 Chevy Express van?

need to fix my express van .


Where is blower control module and blower motor on 2002 Chevy van?

, when you look the motor from the front it is located at your top left on the fire wall Close to the battery Mario