0
What else can I help you with?
What is the torque spec for a Chevy flexplate?
60 ft lbs and dont foreget the red locktight!
60 series Detroit diesel engine torque spec?
hi what is the sequence and torque on engines detroit diesel 60 series 12.7L 430/470 horse power ...
Head bolt torque specs on 1991 Chevy 350?
60-to 70 ft. lbs. of torque 60-to 70 ft. lbs. of torque
What is the torque spec for 1973 harley fx rear axle nut?
55 to 60 foot pounds.
What is the torque on a 78 Chevy 350 heads?
60 foot pounds
What is the torque setting for the crank shaft pulley on a 350 Chevy engine?
60 ( ft. lbs )
What is front axle shaft nut torque spec for 1998 GMC jimmy?
The 1998 GMC Jimmy front axle shaft torque specification is 60 pounds. You want to make sure that you do not over torque the axle shaft, as you can ruin the axle bearing.
What is the torque spec for the pressure plate bolts on a 12.7l 60 series detroit?
55 ft lbs then 120 degrees 55 ft lbs then 120 degrees
What are the torque specs for the upper and lower intake in a Chevy Venture?
AnswerIf this is the V-6, then you must have a common problem...lower intake leaks coolant.The torque spec for the lower manifold is:First pass: 60 inch poundsSecond pass: 110 inch poundsLast (outer bolts only): 18 foot poundsUpper intake is a total 88 inch pounds in at least two steps.Randy
What is the torque for a fly wheel on a 73 Chevy 350?
The torque specification for a flywheel on a Chevy 350 engine is typically around 60-65 ft-lbs. It is important to consult the specific vehicle manual or contact a professional mechanic for accurate torque values and proper installation. Applying the correct torque is crucial to ensure the flywheel functions properly.
What spec is the Jake brake leveling screw locknut torque on series 60?
The torque specification for the Jake brake leveling screw locknut on a Detroit Diesel Series 60 engine is typically around 30-35 lb-ft. However, it's important to consult the specific service manual for your engine model, as torque values can vary slightly based on the configuration and year of manufacture. Always ensure that you use a calibrated torque wrench for accurate measurements.
What are the torque specs for a 2000 Malibu Chevy cylinder head?
Tighten the bolts to 60 nM (44 ft. lbs.) in sequence. Tighten the bolts to 60 nM (44 ft. lbs.) in sequence.
