0
The 1998 GMC Jimmy front axle shaft torque specification is 60 pounds. You want to make sure that you do not over torque the axle shaft, as you can ruin the axle bearing.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you change cv joints on 1998 Nissan Altima?
This should answer your question? I used it to help me replace mine on my altima. forums.nicoclub.com/zerothread/157923
How much should it cost to replace front wheel bearing on a 1998 trail blazer?
I paid $495.00 dollars
Cam sensor located Pontiac grand prix se 1998 3.1?
in the front where the belt is at unders the power steering pump .
Location of the starter motor on a 1998 mk6 ford escort zetec - front or rear?
The 1998 Ford Escort starter motor is located on the rear of the engine. The starter motor will be on the right hand side, near the bottom of the motor.
How do you replace starter on 1998 Harley fat boy?
disconnect the battery, pull the primary cover and remove the jack shaft, You will need a 1/4 Allen socket to get to the starter bolts. remove battery pos cable from starter and remove
Change 1998 jimmy 4x4 front wheel bearing?
How do you change a 1998 jimmy 4X4 front wheel bearing ?
What is the torque on 1998 VW Beetle rear axle nut?
what is the torque 1998 beetle front spindle
What is the drive shaft wheel nut torque setting on a peugeot 106 1.1 1998?
245 lbs in haynes
What is the wheel bearing torque specs in ftlbs on a rear wheel bearing for a 1998 Honda Accord?
what is the torque on front wheel bearings for 1998 honda accord
How do you change torque converter seal on 1998 Plymouth breeze?
You have to pull drive shaft and take off trans- the front pump seal is on the front of the trans behind the converter. It looks just like the one at the end of your tail shaft. Except for the labor, replacing seal itself is easy once you get to it. If you are mechanically inclined and have the tools, you can do it yourself.
What is the front axle nut torque on a 1998 Ford Contour?
270 Nm
What are torque specs on front axle on 1998 Chevy Malibu?
It is 66 ft-lbs, and 46 ft-lbs for driveplate-to-torque coverter bolts.
Headlights in a 1998 gmc jimmy?
there are two small screws and a torque screw above each headlight. i want to remove mine also but im pretty sure you have to remove the front bumper also. i haven't gotten that far.... too lazy
What is the torque setting for the front wheel bearing nut on a 1998 ford puma 1.7?
290 nm front wheel bearing 1.7 puma
How many does 1998 gmc jimmy seat?
2 bucket seats in front 1 bench in back
Where is the crank shaft sensor on a 1998 BMW 740il?
The crank shaft sensor on a 1998 BMW 74Oil is located down near the crank on the front of a motor. It is super easy to replace but sometimes reaching the harness wire is a little bit difficult.
Dodge 1998 front axle nut size?
The axle shaft nut takes a 1 and 11/16 inch socket
