This should answer your question? I used it to help me replace mine on my altima.
forums.nicoclub.com/zerothread/157923
take apart the drive shaft
The bleed screw on the calipers of brake systems are for 'bleeding' air out of the brake lines.
To change the license plate lamp on a 1998 Bravada, locate the bulb. Visit an auto parts store to obtain the exact bulb and screw it in place.
Follow the plug wires form the spark plugs. If they go to a cylinder then that's the cap. It should unbolt out or have fasteners. It could be a DIS distrbutorless ignition system. Meaning the plug wires go into a square block which is the ignition coil assembly. These systems do not have a cap and rotor.
yes the s10s were the same from 94 to 04 exept for the interior and grill change in 1997-1998
Ball joints only really need to replaced when they are going bad. Usually you can tell if you put one hand on the 12 oclock position and the other on the 6 oclock position and try to wiggle the the tire. If it wiggles this way then ball joints are going bad. (Jack the vehicle up first). If you put one hand on the 3 oclock and the other in the 9 oclock position and wiggle it and it moves then the tie rods are going bad. If the whole tire moves in and out then the bearings are usually going bad. Hope this helps.
How to remove the front bumper to a 1998 Nissan Altima?
What do you torque the head bolts on a 1998 nissan altima 2.4 l
The crankshaft sensor on the 1998 NISSAN ALTIMA is located next to the radiator side of the harmonic balancer
timing chain diagram for 1998 Nissan altima
where is the oxygen sensor in a 1998 Nissan altima 2.4gxe
hammer
Motor
1
Below
1998 Nissan Altima GXE has a timing chain. Check your model at: http://www.courtesyparts.com/watches-c-7738.html
when it breaks More info here: http://www.nissanforums.com/l30-1998-2001-altima/125696-timing-belt-chain.html
I'm trying to change the headlamp and I'm having difficulty myself too! Very good question!