0
Here is the engine torque specifications of 1997 Buick Lesabre:
- 3,785 cc 3.8 liters 6 V 90° front transverse engine with 96.5 mm bore, 86.4 mm stroke, 9.4 compression ratio, cast iron block, cast iron head, overhead valve, automatic valve adjustment and two valves per cylinder
- Unleaded fuel
- Fuel economy EPA highway (l/100km): 7.8
- Multi-point injection fuel system
- Main 68 liter fuel tank
- Power: 153 kW , 205 HP @ 5,200 rpm; 230 ft lb @ 4,000 rpm
What else can I help you with?
What is bolt torque for lower intake manifold for 97 buick lesabre?
The 1997 Buick LeSabre intake manifold bolt torque specifications is 45 pounds per square inch. The manifold bolts should be torqued in 15 pound intervals.
What are the torque specs for 1999 Buick LeSabre front hub and wheel bearing?
118 ft lbs 1997-2004 Buick LeSabre
Where is the ecu located on a 1995 Buick lesabre?
where is the engine controle module located in a 1995 buick lesabre
What are the torque specs for 1989 Buick LeSabre front hub assembly?
$1
Where is the solenoid on 1998 Buick lesabre?
The 1998 Buick LeSabre solenoid can be found on the firewall in the engine compartment. There will be three solenoids on the firewall.
Does 1992 Buick lesabre have timing chain or timing belt?
The 3.8 litre V6 engine in a 1992 Buick LeSabre has a timing CHAIN
How much transmission fluid dexron 111 is needed for a 3.8 engine size of 1988 Buick Lesabre?
With the torque converter about 11 quarts. without about 7 quarts.
Is there a diagram of the engine of a 2003 Buick leSabre limited?
Thanks
What is the torque value for front brake caliper 2000 Buick Lesabre?
33 Ft lbs
Where is the starter on a 1989 Buick Lesabre?
The starter on a 1989 Buick LeSabre can be found on the driver's side of the engine. It is down low, back by the bell housing for the transmission.
What is the torque specs for the brake caliper mounting bolts on a 2000 buick lesabre?
75 ft lbs
What is the torque spec for 2004 3.8 Buick lesabre lower intake manifold?
The torque specification for the lower intake manifold on a 2004 Buick LeSabre with a 3.8L engine is typically around 11 lb-ft (15 Nm). It's important to follow a specific tightening sequence in multiple steps to ensure even pressure across the manifold. Always refer to a repair manual for the precise procedure and torque sequence for your specific vehicle.
