0
What else can I help you with?
Where is the plug or screw to drain the radiator on a 1998 Cadillac Deville?
difficult to reach.facing front end,lower rt corner,backside of radiator,look or feel through holes in frame.rubber splash panel must be snapped loose for access.
What are threaded jack screws holes on the rotors for?
the threaded holes are for removing the rotor. If the rotor does not come off with ease, a bolt of the same size can be inserted in and the rotor "pryed" off, using a socket set.
1995 dodge Dakota trasmision lines leak after replacing radiator how do you stop this are the o rings in end bad?
I take it hat the lines are leaking at the radiator. Check the flares on the inside of the flare nut. Use tread sealer on the treads. Look for any cracks or pin holes in the lines. Worse thing you may of cross threaded when installing the lines to radiator.
How can you repair holes in metal?
thin material holes can be welded and ground flush, think material can be threaded and plugged. Bondo works, too.
What is the size of the 2 threaded holes in a 2002 Chevy Tracker brake drum?
14 mm
Marlin 55 Goose guns have 2 threaded holes in the rear of the receiver what are they for?
Peep sight
What type of simple machine are shoelaces and the holes they are threaded through?
Shoelaces and the holes they are threaded through represent a pulley system simple machine known as a mechanical advantage. By pulling on the shoelaces, you can control the tension, allowing you to tighten or loosen the shoes easily.
How do you fit a rear spoiler to citroen saxo?
drill 2 holes at each end of the bootlid to correspond to the threaded bolts on the spoiler then sit the spoiler in the holes and bolt from inside.
Where are the spark plugs on a 1995 Cadillac eldorado?
The Eldorado of 1995 contains a Northstar transverse (sideways) mounted V-8 engine. The spark plugs on the forward bank of cylinders are right in front of you when you lift the hood. Look for four black wires coming out from under the engine shield and going down in to four litte holes on the camshaft covers. The rear bank are a little harder to get to, but they're back there, on the opposite side of the engine.
Why are there 2 threaded holes on the exhaust manifold of a 1995 Chevy Caprice Classic 5.7 liter but only 1 hole on the pipes that bolt onto it?
The threaded holes are the air reactor [AIR] fitting, an exhaust gas recirculation [ERG] fitting or choke stove. Check out DormanProducts.com. copmagnet95@hotmail.com
How do you remove rear drum on a 2003 Chevy Tracker 4-cylinder?
On the drum there is 2 threaded holes. Take 2 bolts and thread them into the holes, until the cover comes off.
Where is temperature sensor for radiator fan?
It is on the bottom side or it is the line holes on the front.
