0
What else can I help you with?
What is the intake manifold torque pattern for a 1977 Chevy Blazer with a 305?
start with center bolts and work your way out in a circular patternaltenating from side to side
How to replace the Intake manifold gasket on a 1996 Chevy Astro?
Remove the intake manifold retaining bolts from your 1996 Chevy Astro Van. Remove the manifold gasket and clean the surface. Reverse the process to install the new intake manifold gasket.
Where is the thermostat located on a 1997 Chevy Blazer?
located on the intake manifold just follow the upper radiator hose to the engine should be 2 bolts holding the thermostat housing down.
What is the torque for the intake manifold bolts on a 91 Chevy 5.7liter?
35 Ft. Lbs
What is the torque for intake manifold on a 350 Chevy?
The 350 cubic inch Chevrolet intake manifold bolts have a torque specification of Haiti pounds psi. The bolts should be torqued at 40 pound intervals.
Where is the EGR Valve located on a 1993 Chevy S10 Blazer 4.3L Vortec VIN W?
The EGR valve is located under the air intake on the intake manifold, you must remove the intake hose to access it thare are two bolts oposit each other, it's not that bad to remove.
What is the torquing specs for the bolts on a 1999 blazer 43 intake manifold The book gives 132 pounds but this seems too much?
I FOUND THIS AT WWW.AUTOZONE.COM, CLICK ON VEHICLE SPECS . For your 1999 CHEVROLET TRUCK BLAZER 2WD: INTAKE BOLT TORQUE FOOT POUNDS (FINAL TORQUE) TORQUE LOWER MANIFOLD BOLTS TO 27 IN/LBS TORQUE LOWER BOLTS TO 9 FT/LBS TORQUE LOWER BOLTS TO 11 FT/LBS TORQUE UPPER MANIFOLD BOLTS TO 44 IN/LBS TORQUE UPPER MANIFOLD BOLTS TO 7 FT/LBS (TO TORQUE BOLTS & NUTS, START IN CENTER USING CRISSCROSS PATTERN)
Where are the fuel pump relay and the fuel pressure regulator on a 1994 Chevy Blazer S10 4.3L It is running very sluggish especially uphill fuel pump and fuel filter are good and plugs were changed?
the fuel pressure regulator is located inside the polycarbonate(black plastic looking) intake manifold. You have remove intake manifold from the engine and "split" it apart on a workbench or suitable supporting device because the bolts that hold the 2-piece intake manifold together are located on the bottom of the manifold. the fuel pressure regulator is located inside the polycarbonate(black plastic looking) intake manifold. You have to remove the intake manifold from the engine and "split" it apart on a workbench or suitable supporting device because the bolts that hold the 2-piece intake manifold together are located on the bottom of the manifold.
Why is my Chevy Venture overheating?
If the usual problems don't reveal the prolem have your mechanic check the intake manifold. These engines have a tendency to loosen the bolts on the intake manifold and the leak will damge the gasket. In time it will get worse.
Where is erg valve on 93 Chevy Silverado?
It is on the back of the intake manifold, Its round and silver in color and has two bolts that hold it on.
Why do caliper bolts back out on a K5 Chevy Blazer 44?
Why do caliper bolts back out on a Chevy K5 Blazer 4*4?
3.4L intake manifold gasket directions?
Try Retightening intake manifold bolts first...............
