Trick question. there isn't a 94 olds aurora.
Intake manifold torque specifications for the Olds 403 is listed as 30 ft-lbs.
i am replacing the starter on olds 1995 aurora
alero intake manifold torque specs
The Olds Aurora has the starter sitting inside of the engine. You'll need to take off the intake manifold to get to it, and even then its a tight squeeze. Once you get the intake manifold off it will be highly visible.
From 1995 Aurora Service Manual page 6A8-20/Lower Intake Manifold. Tighten the intake manifold bolts twice to 10 N*m (88 lb. in.) following the sequence in Figure 29. -----3-----1-------5 -7-------------------9 8------------------10 ---4--------2-----6
Cast iron intake is 30 lb/ft
The Olds Aurora has the starter sitting inside of the engine. You'll need to take off the intake manifold to get to it, and even then its a tight squeeze. Once you get the intake manifold off it will be highly visible.
1996 Olds Aurora knock sensor is located under the intake manifold requiring removal of the intake manifold. Once the manifold is removed it is easy
Remove intake manifold from top of engine. It's underneath See previous question about location of manifold
The starter is located under the intake manifold. It is in the VALLEY between the cylinder heads. Under the hood Under the hood
It's under the BIG pretty plastic cover that dominates the engine compartment, it's held on by a couple screws.
103 ft lbs. See torque specifications chart at: http://cds.activant.com/C2C/C01/35/192/157591741.pdf