0
What else can I help you with?
Ford Fiesta 1.25 zetec drive belt diagram?
How to route Ford Fiesta 1998 Zetec alternator belt
Where is the fuel pump on a Ford Fiesta zetec 1998?
it is located in the fuel tank. Remove the rear seat and you will find a blanking plug and on removal will reveal it.
What is the valve clearance on a 4d56 1998 Mitsubishi piclup?
L200 2.5td with 4d56 engine : valve clearances are 0.25mm for both inlet and exhaust valves.
Does a 1998 fiesta 1.25 LX zetec have a timing belt or chain drive?
belt driven engine 10 years or 100k which ever comes 1st
Your 1998 ford fiesta 1.25 zetec lx is blowing warm air when it should be cool Does this mean the thermostat needs replacing?
Chances are this is the heater valve no longer functioning. This is located behind the plastic bulkhead panel at the back of the engine bay, under the bonnet. The valve will have 2 hoses (15mm approx) into and out of it Check you have power to and from the valve. If not rectify this fault first. It's a simple matter to replace the valve, drain enough water, remove hoses, unbolt valve, replace.
How do you bypass a immobilisers no a s reg escort diesel van?
my 1998 ford fiesta lx zetec wont start againt fuel pump not working or is it the immobilizer how can i tell?..and can i bypass the immobilizer
Does a 1998 ford focus 1.6 zetec have a timing Belt or chain?
1.6 zetec s has a belt not chain
Where can you find a picture of the engine temp sensor location on a 1998 ford contour zetec engine?
Where can i find a picture of the engine temp sensor location on a 1998 ford escort zetec engine?
How do you adjust the tappets on a fiesta 1998?
To adjust the tappets on a 1998 Ford Fiesta, first ensure the engine is cool and remove the valve cover. Then, using a feeler gauge, measure the clearance between the tappet and the rocker arm for each valve. Adjust the tappet clearance by loosening the lock nut and turning the adjusting screw until the proper clearance is achieved, then tighten the lock nut. Finally, recheck the clearance to ensure it is within the specified range before reassembling the valve cover.
Is a 1998 fiesta a mark 4?
YES
How come my heater on my Ford Fiesta 1998 only works on number 4?
how is it my heater control on my ford fiesta flight 1998 only works on no. 4
How do you change a fan belt on fiesta 1.25 1998?
it all depends on what year it is!! 1998
