answersLogoWhite

0

Make sure the heater control valve is closing. Unfortunately, that can be a difficult process and usually involves disassembling the heater assembly under the dash.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Heater is not blowing out hot air blows out cool air flushed radiator changed thermostat checked fuse coolant level is ok what is next?

You might have bad actuator that opens and closes airways.


Why is my vehicle's defrost blowing cold air when set at warm?

If the temperature cannot be changed for any of the direction settings, e.g., defrost, vents, floor, then the problem is very likely to be the blend door actuator motor.See "Related Questions" below for more


What makes the sound of a clarinet?

Sound is produced by blowing through the horn, causing an attached reed to vibrate. By convering or uncovering the holes/keys the pitch is changed from higher to lower.


How has the assembly line changed over the years?

it changed by... well it changed... It just changed!


Is glassblowing a chemical or physical change?

Glass blowing is a physical procedure, the chemical formula is not changed.


How do you get a diesel to stop blowing black smoke?

Have your injectors checked or changed, burnng to much fuel


You have a 1999 mercury cougar that is blowing cold air you have changed thermostat and is sill blowing cold air?

i think that it is determined by the position of the sun. cheers-rhys stannard 10DL


Chevy changed thermostat still no heat?

With vehicle warmed up and running feel both heater hoses with your hands. If one hose is hot and the other is cold or luke warm, the heater core is plugged. Flushing the heater core should help. If both heater hoses are hot, the temp blend door actuator behind the dash may be broken in which case the entire dash assembly would have to be removed to repair/replace the temp blend door actuator.


What occurs in a cell causing a changed in the DNA?

A mutation.


How did the assembly line changed the way people worked?

because


Can the balljoints on a 2000 mercury mountaineer be replaced?

I believe the lower balljoints can be changed , but the upper control arm assembly with the balljoint has to be changed


The rear ac works but your front ac doesn't you changed the blend door actuator on your ford windstar1999 what could it be?

expantion valve. this vehical has two