0
If a 1990 Ford Probe only runs in reverse, it may indicate a problem with the transmission, such as low fluid levels, a failing transmission pump, or internal damage to the transmission components. Additionally, issues with the transmission linkage or control module could prevent the vehicle from shifting into forward gears. It's important to diagnose the issue thoroughly, as continuing to drive the vehicle in this condition can lead to further damage.
What else can I help you with?
What years did the Ford Probe have a 3.0-v6?
never only the Ford Taurus
What years did the Ford Probe have a 3.0 v6?
never only the ford taurus
How fast does a Ford Probe go?
My 95 Probe GT has 140 on speedometer but I have only done 100+ in it, but I am a chick.
1995 ford probe: what could be the cause of 'no spark' after replacing timing belt distributor perform a tune-up and and oil change note: you am able to start the car only after letting it cool down.?
NO SPARK TO DISTRIBUTOR CAR WILL TURN OVER BUT WONT START 95 FORD PROBE
How much is a brand new Ford Probe in Dallas, TX?
The Ford Probe was discontinued in 1997 after 8 years of production. You can only buy them used. The comparable vehicle would be the Ford Fusion which has a MSRP of 21600$.
Why does your heater only work when car is moving 97 ford probe?
low on coolent
How do you replace the ball joints in a 1990 Ford Probe?
This is not an easy job to do yourself if you only have little knowlege. Get the Haynes Manual MAZDA 626 & MX6 FORD PROBE 1993_2001. No. 61042 This will tell you in detail how to remove & replace the balljoints . This is not an easy job to do yourself if you only have little knowlege. Get the Haynes Manual MAZDA 626 & MX6 FORD PROBE 1993_2001. No. 61042 This will tell you in detail how to remove & replace the balljoints . This is not an easy job to do yourself if you only have little knowlege. Get the Haynes Manual MAZDA 626 & MX6 FORD PROBE 1993_2001. No. 61042 This will tell you in detail how to remove & replace the balljoints .
Where do you pour coolant in a Ford Probe 1998 2.4?
no such thing man only made the probe till '97 and only put a 2.5 v6, 3.0 v6, and 2.0 i4 in them quit screwin around
What would be the cause of a 1993 ford probe with a 2.0 engine to stall out while driving down the highway?
had same problem with my probe stalling whilst driving after stopping short spell and would then restart. answer was located in immobilizer circuit which cut in at wrong times only cure was to have immobilizer disconnected.
How many reverse lights does a Ford kA have?
It has only one reversing light :)
How many radiators in a 1994 Ford Probe?
For a 4 cyl. there is only 1. For a V6 there is 1 for the water and 1 smaller for the oil.
Why would a 1994 ford probe se run on only 3 cylinders?
plug wiers or plugs. it could also be somthing with the distributor.
