answersLogoWhite

0

Running slow with high rpm is a sign of slippage. If the vehicle is a straight drive then the clutch is not grabbing and is slipping, if its an automatic then the transmission is slipping internally.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Where is the orifice tube located on a 1996 Ford Contour Sport?

on my 1999 Ford Contour the oriface tube was located under the hood on the firewall on the high pressure line, below the larger low pressure line, need to buy disconnect tool fuel/ac line tools, remove and then along the line is a connection with two nuts 22mm and 19mm unscrew and remove hose


Why do you have the high speed only on the heater in your 1998 Ford Contour?

Bad blower resistor. I just replaced mine.


Why does my 1996 4 cylinder Ford Contour just revs high when started sounding like the gas is applied let go then applied again over and over?

check for vaccum leak(around intake and all vacum lines


1996 ford F250 Fuel pump High pressure?

The 1996 Ford F2 50 high pressure fuel pump is located inside of the gas tank. The high pressure fuel pump can be purchased from most auto-parts stores.


What is the ac pressure on a Ford Contour?

Low side pressure is normally 28-38 high side pressure is typically 100 + outside temperature


What causes high carbon at idle on smog check 1995 ford ranger 2.3?

ford suck. go Chevy


Where is headlight high beam relay on a 98 ford contour?

On a 1998 Ford Contour, the headlight high beam relay is typically located in the fuse box under the hood. To find it, open the hood and look for the fuse box, which is usually near the battery. Inside the fuse box, you should see a diagram that indicates the location of the high beam relay. If you're unable to locate it, consult the vehicle's owner manual for more detailed information.


Your car 1996 Ford Contour GL 2.0 L is still high tempt to close red when you replace new theorems sensor fan sensor gang and changed new antifreeze How can you get tempt go down normal?

It could just be that the temperature sensor or the gauge may be poorly calibrated.


Why will my 95 Ford Ranger low beams work but not the high beams?

If it's the same as the 1996 Ford Ranger , fuse # 33 is a 15 amp fuse for the High beam lamps


How do you fix a timing chain on a 1997 Ford Contour GL?

It is a timing belt and it is best to replace the idler, tensioner and belt at once. Also, the water pump if it is high mileage.


What causes high oil pressure in a Ford 390?

Could be too thick of oil used.


Is there a fuse on 96 ford explorer high mount brake light?

Yes , fuse # 2 , 7.5 amp for High - mount stoplamp on your 1996 Explorer