0
What else can I help you with?
Why isn't my 04 gmc Yukon firing?
Check the ignition coils and the crank sensor for the Yukon. Either one of these could be bad and cause the problem.
What could cause a knocking noise on front passenger side of car when turning?
mine doing the same when turning been to garage could be broke spring or strut top bearing .
Why could Germany not pay back its debts?
cause they started WWII
Is there sports in the Yukon?
there could possible be hockey
What is the cause of your windshield wipers not turning on?
Most likely fuse(s). Could be the switch too but probably fuse.
2001 Yukon XL dies either at stop light or driving down road starts right back up after stopping and turning ignition off what could this be?
Check Battery Terminals For Corrossion Or If They Are Loss
2002 Explorer sport trac roar from rear end?
My 2002 sport trac has just started a very noticable roar when going done the road just started what could be the cause My 2002 sport trac has just started a very noticable roar when going done the road just started what could be the cause
What would cause a grinding or rattling sound when accelerating from a stop or when turning?
if its a front wheel drive vehicle then it could be the axels
What could cause the oil to run out the front end of Mark8 when started?
Front engine seal?
Yesterday i put on a show with my band and this morning i started coughing blood. what could be the cause?
pneumonia
Why is it so hard to turn right on a gmc Yukon 2001?
Turning right in a 2001 GMC Yukon can be challenging due to its large size and turning radius, which makes maneuvering in tight spaces more difficult. Additionally, the vehicle's weight and body design can affect handling, particularly at lower speeds. If there are issues with the steering system or suspension, this could further complicate right turns. Regular maintenance is crucial to ensure optimal handling and performance.
What could cause a loud thud noise when turning steering wheel left and right and when going over bumps?
could be control arm bushings gone bad
