0
What else can I help you with?
How do you install mopar small block distributor?
get #1 cylinder on top dead center and then put the distributor rotor bug a hair before the #1 plug wire on the distributor and drop in down into the engine and all should be fine.
Which direction do you set a distributor drive gear in a mopar 440?
In a mopar 440 the distributor drive gear notch is set inline with the crankshaft, but it's just a reccomended starting point as long as you have enough space to turn the distributor in either direction to adjust timing when installed.
Which direction does the distributor drive gear face in a mopar 440 engine?
the drive gear slips through the distributor opening in the block. there are two kind, pinned and shrink fit. if you have the gear off the shaft to the oil pump the flat side goes down and the end with the slotted end is facing up so you can adjust distributor timing at the spark plug. hope this helps.
Identifying a 318 or 360 dodge motor?
mopar motors have the number stamped on the side of the engine block
How do you advance a mopar 318 distributor cap?
you do not adjust a distributor cap you adjust the timing.
How do you install mopar 440 distributor gear?
To install a Mopar 440 distributor gear, start by removing the old gear from the distributor shaft if necessary. Align the new gear with the shaft, ensuring the keyway fits properly, and then press it onto the shaft until it is securely in place. Use a small amount of engine assembly lubricant on the gear to ensure smooth operation. Finally, reassemble the distributor and reinstall it into the engine, aligning it correctly with the timing marks.
On a 1995 Dodge Van 318 V8 the engine cranks fine but there is no spark to the distributor could this be a SMEC problem?
The distributor induction coil may not be sending a signal to trigger the spark. Wiggle that pigtail wire coming out of the distributor boy and see if the engine will start. If it does, then install a new induction coil. The wires coming out of the distributor body sometimes develop breaks. If the dealer doesn't have the coil, then you can use a substitute Mopar part from NAPA, however, the Mopar part doesn't fit as tight into the distributor body as the original part. Plan to pay about $50 for the part. --------------------------------------------------------------------------------------------- Save the screws from the original part. If I remember correctly, the replacement screws with the Mopar part are bit short.
What mopar block number is 2468230?
318
Where is the oil pressure switch on a Mopar 383 engine?
its in the center rear of the engine. There are 2 ports in the block, the sending unit is usually toward the left(drivers side) on a angle.
I would like to know if there is a shorty filter for header clearance to take the place of a ph8a for a small block mopar This is for a 500h.p. engine?
you will have to check with a parts store to see if another filter will cross reference and fit your engine that is smaller. get an adapter to stick the filter out in another direction some headers require it
What is the name of the small block mopar transmission?
904 torqueflite
What is the name of a dodge charger engine?
Mopar or hemi
