answersLogoWhite

0

The rocker arm.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

You have long push rods and short push rods which ones go where?

long ones are exhaust


How do you replace push rods on a 1996 dodge neon?

Being an overhead cam engine, a Neon doesn't have push rods.


Why does 3.4 make noise after installing push rods?

Double check the new push rods, they come in many lengths.


Can you run stock push rods with roller rockers?

It's not really about what rockers you run. If you have guide plates, you need hardened push rods.


How to replace push rods on a 2002 Chrysler sebring gtc?

A 2002 Chrysler Sebring has an overhead cam engine. That means it does not have push rods.


What do you torque the rocker arms to when you reistall push-rods on 2003 3.4 Pontiac?

what should you torque the rocker arms to when you reinstall the push-rods to on a 3.4 pontiac


Is it possible to damage lifters if valves were adjusted wrong and resulted in bending the push rods?

Yes, it's possible. But the push rods usually take the worst of it.


Where can you find push rods for a 1973 dodge dart swinger 318V8?

Any good parts store should be able to get the push rods for you and if they can't try Manciniracing.com.


Dose it matter which end of oil rods are up or down?

If you're talking about the push rods, no it doesn't matter.


What is the core of the engine?

Its internal workings, crankshaft, pistons, rods, rings, lifters, push-rods and so forth......


Chevy 350 how to replace push rods?

Pull the valve covers off. loosen the rocker arms with out taking them all the way off. then you can turn the rocker arms to pull the push rods out. replace push rods, and tighten rocker arms back down and put valve covers back on


Do you have to remove push rods to install new gaskets?

In most cases, you do not need to remove push rods to install new gaskets, as gaskets are typically located on the engine's cylinder head or oil pan, which can be accessed without disturbing the push rods. However, if you are replacing head gaskets, you may need to remove the cylinder heads, which would involve removing the push rods. Always refer to the specific service manual for your vehicle for detailed instructions.