0
What else can I help you with?
How do you remove and replace distributor on 5.7 vortec 1997?
To remove and replace the distributor on a 1997 5.7 Vortec engine, first disconnect the battery and remove the ignition coil and any wiring connected to the distributor. Mark the position of the distributor housing and rotor for proper alignment during reinstallation. Remove the distributor hold-down bolt and carefully lift the distributor out, noting the orientation of the gear. Install the new distributor by aligning it with the marked position, securing it with the hold-down bolt, and reconnecting all wiring and the ignition coil.
Where is camshaft position sensor on 5.7 Vortec?
The Camshaft sensor is located in the distributor.
Does a 96 Yukon 5.7 vortec have a camshaft position sensor?
yes, under the rotor in the distributor
Where is the cam position sensor on 97 Chevy Tahoe 5.7 vortec?
It's located in the distributor under the rotor.
Why 1996 vortec won't start after reinstallion of distributor?
As long as you marked or took note on what position the distributor cap was in when you took out the distributor, you can turn the distributor gear 180 degrees and reinstall it. There is a flat piece in the end of the distributor that looks like a flat head screwdriver and sometimes that turns when you take the whole thing out. This would put you 180 off on your timing. Try that and then reinstall and that may be your only problem.
How do you replace a distributor on a 5.7L vortec?
To replace the distributor on a 5.7L Vortec engine, first, disconnect the negative battery cable and remove any components obstructing access to the distributor. Mark the position of the old distributor and the rotor's orientation for proper alignment during reinstallation. Remove the distributor hold-down bolt and lift the distributor out, taking care not to disturb the engine timing. Install the new distributor, aligning it with your marks, secure it with the hold-down bolt, and reconnect any components and the battery.
Does a 1994 4.3 vortec have a cam shaft sencer?
It is in the distributor.
Do 350 vortec motors have a distributor?
YES, The 350 Vortec does. It is in the back top side of the engine. All the plug wires go to it.
What is the firing order for 1995 Chevy blazer v6 vortec and diagram where is number 1 on the distributor?
Standing in front with the hood open, looking at the distributor, #1 is at the 6 O'clock position, from there clockwise it is 1, 6, 5, 4, 3, 2.
What is the distributor cap firing order on a 5.7 gmc vortec engine?
18436572
Will a distributor from a 90 Chevy 350 work in a 99 Chevy 350 vortec?
NO.
Does a Chevy 2002 s10 4.3 liter vortec engine have a distributor?
Yes.
