answersLogoWhite

0

To replace the distributor on a 5.7L Vortec engine, first, disconnect the negative battery cable and remove any components obstructing access to the distributor. Mark the position of the old distributor and the rotor's orientation for proper alignment during reinstallation. Remove the distributor hold-down bolt and lift the distributor out, taking care not to disturb the engine timing. Install the new distributor, aligning it with your marks, secure it with the hold-down bolt, and reconnect any components and the battery.

User Avatar

AnswerBot

2mo ago

What else can I help you with?

Related Questions

How do you remove and replace distributor on 5.7 vortec 1997?

To remove and replace the distributor on a 1997 5.7 Vortec engine, first disconnect the battery and remove the ignition coil and any wiring connected to the distributor. Mark the position of the distributor housing and rotor for proper alignment during reinstallation. Remove the distributor hold-down bolt and carefully lift the distributor out, noting the orientation of the gear. Install the new distributor by aligning it with the marked position, securing it with the hold-down bolt, and reconnecting all wiring and the ignition coil.


Does a 1994 4.3 vortec have a cam shaft sencer?

It is in the distributor.


How do you change the power steering pump on a 96 Chevy suburban with a 57l vortec?

need a puller to remove the power steering pump pulley, then remove the bolts holding the pump on


Do 350 vortec motors have a distributor?

YES, The 350 Vortec does. It is in the back top side of the engine. All the plug wires go to it.


What is the stock horsepower for a 57L V8 Vortec's from 1988-2000?

Look it up. Google search. I had bought a new 1995 5.7 and it was rated at 250 HP. The 1996 Vortec model was rated at 275 HP and HP continued to climb as every year passed. Mark


What is the distributor cap firing order on a 5.7 gmc vortec engine?

18436572


Does a Chevy 2002 s10 4.3 liter vortec engine have a distributor?

Yes.


Where is camshaft position sensor on 5.7 Vortec?

The Camshaft sensor is located in the distributor.


Will a distributor from a 90 Chevy 350 work in a 99 Chevy 350 vortec?

NO.


Which wire is number 1 on vortec 4.3 distributor cap?

where is number one on a vortex 4.3 v-6 distributor cap


96 Chevy k1500 350 vortec wont fire and no fault codes?

I would replace the ignition module in the distributor. Also need to make sure the coil and wire is good too.


How do you change the ignition coil on a chrysler Sebring with the 2.5?

You have to replace the distributor assembly.You have to replace the distributor assembly.