A camshaft position sensor reads the location of the camshaft and sends that information the engine computer. This is needed for fuel and ignition timing.
yes
That year did not have 1
in the distributor located on top rear of motor
2002 Chevrolet Tahoe has two oxygen sensors How do I check them ?
It is mounted on the passenger side/right side in the timing cover. one bolt holds it in place.
The cam shaft position sensor is located under the distributor cap. You can replace this easily by undoing the screws holding on the distributor cap, remove and replace the sensor, then just replace the distributor cap.
its in the glove box
On a 5.3. at the top rear of the engine, behind the intake manifold. I is very difficult to get to without first removing the intake manifold.
Wire diagram for 02sensor on 95 Chevrolet tahoe
The crank position sensor on a 2003 Chevrolet Tahoe typically uses a 10mm bolt. It's recommended to use a socket or wrench that fits securely to avoid stripping the bolt. Always check the vehicle's service manual for the most accurate specifications and torque settings.
That year did not have a Manifold Air Tempture sensor / MAT sensor, no need for it on the Throttle body injection system.
you have to remove the intake, and there are 2 knock sensors.