answersLogoWhite

0

its your idle controle i have a 1992 same problem just havent had time to fix it if you shut the car off for a second it will reset.THE DISENGAGED THROTTLE CABLE CAN INTERFERE WITH THETHROTTLE CAM MECHANISM, RESULTING IN THE THROTTLE STICKING IN EITHER THE OPENPOSITION OR CLOSED POSITION. WHEN THE THROTTLE STICKS IN THE OPEN POSITION,UNWANTED VEHICLE ACCELERATION WILL OCCUR WHICH MAY CAUSE AN ACCIDENT. Remedy: INSPECT THROTTLE CABLES TO ENSURE THE THROTTLE CONTROL CABLE IS FULLY SEATED IN THE RETAINING BRACKET AND INSTALL A CABLE TIE STRAP TO SECURE THE CABLE IN ITS CORRECT SEAT.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

How do you service a 1995 Cadillac Eldorado when the service ride control warning light is on?

this means you have a failure, a shock or the ride control computer has gone bad


1992 Cadillac eldorado service engine light on?

service engine soon 1992 eldorado


How do you reset the 'service ccr' light on a 1991 Eldorado?

To reset the service CCR light on a 1991 Eldorado, disconnect the battery for 10 minutes. Reconnect it and start the car.


How do you reset service engine soon on 96 eldorado?

jaseph Stalin


What causes the service emissions system light to come on Cadillac eldorado?

There are about 30 different sensors which monitor emission control systems components. It could be any one of them. Have a dealer run a diagnostic scan.


1988 Cadillac eldorado ac compressor installation?

Where is the a.c service port located


Where can you find the electronic control module on a 1983 Cadillac Eldorado?

On a 1983 Cadillac Eldorado, the electronic control module (ECM) is typically located under the dashboard on the driver's side, near the steering column. It may be mounted on a bracket or directly on the firewall. To access it, you might need to remove some panels or components that obstruct your view. Always consult the vehicle's service manual for detailed instructions and safety precautions.


Where is the timing control sensor located in a 96 Cadillac Eldorado?

In a 1996 Cadillac Eldorado, the timing control sensor, also known as the crankshaft position sensor, is typically located near the crankshaft at the front of the engine. It is mounted on the engine block, often near the harmonic balancer. Accessing it may require removing some components for better visibility and reach. Always consult the vehicle's service manual for specific instructions and diagrams.


Where is the body control module located on a 1992 Cadillac Eldorado?

The body control module (BCM) on a 1992 Cadillac Eldorado is typically located inside the passenger compartment, behind the dashboard. Specifically, it can often be found on the driver's side, near the fuse box or attached to the steering column. Accessing it may require removing panels for better visibility and reach. Always refer to the vehicle's service manual for precise location and removal instructions.


How do you reset service engine soon code on 2001 eldorado Cadillac?

DISSCONECT YOUR BATT FOR 10 seconds...........there you have it


Where is the pcm located on 1996 eldorado?

In the 1996 Cadillac Eldorado, the Powertrain Control Module (PCM) is typically located in the engine compartment, specifically on the driver's side near the firewall. It may be mounted on or near the fender. To access it, you may need to remove some covers or components, so it's advisable to consult the vehicle's service manual for detailed instructions.


How do you reset the service ccr system on the driver information center on a 1991 Cadillac eldorado?

What is needed when the ccr is driver information center