0
The oil pressure indicator is just that. It shows that oil PRESSURE inside the oil journals of the engine is up to the proper level. The oil is pressurized with a mechanical pump, and the oil is pumped through the engine. The pressure is necessary to keep bearings, hydraulic lifters and sometimes timing chain adjusters functioning properly. When the engine is not physically turning, there will be no oil pressure because the pump is not running, so it's perfectly normal and expected that there is no oil pressure when you first turn on the key. Or, in layman's terms, it means your "Oil" light is still working and your Jeep has enough oil in it.....
What else can I help you with?
Why is the security light on after you changed ignition keys?
The security light comes on after you changed the keys in the ignition from the off position to the on position as a confirmation that the electrical components in the dash board are working. It is nothing to be concerned about.
Can you reset the oil light in a Jeep Liberty?
The oil light in a Jeep Liberty can be reset. To reset the light turn the ignition switch on or off without starting the engine. Next depress the acceleration pedal at least three times and then switch the ignition switch in a locked position.
Do you have to turn on the switch to reset the tire pressure light?
Yes, the ignition switch must be in the ignition position -not- the accessory position.
What does it mean when the Malfunction indicator light comes on in a 2002 jeep liberty sport?
what to do when the malfuction light comes on?
Does a 2002 Chevrolet Malibu have an abs brake system?
I feel it does being it is that new. Turn the ignition switch to the "ON" position. If a yellow light comes on saying abs, then it does.
How do you program a key chip for a Mitsubishi outlander?
If you have a key that is already programmed to your Outlander, use that key first. Place it in the ignition and turn to the "on" position five times. A light should come on your dash (looks like a car with a key inside). Once that light comes on, turn to the off position, remove your first key the place the "new" or unregistered key in the ignition and turn to the "On" position (not start). This should program your key to your Outlander.
How do you turn off the maintenance required light on a 2007 Camry?
Turn igniton to on position and put odometer in trip mode, turn off ignition. Hold trip button in and hold it in as you turn ignition to on position, it will flash Turn off ignition. Maintenance light should go and stay off
2003 Jeep liberty engine light comes on?
Have vehicle scanned to determine the problem
How do you reset ml350 service light?
To reset the service light on a Mercedes-Benz ML350, turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within 10 seconds, then turn the ignition off. Finally, turn the ignition back to the "On" position to verify that the service light has been reset. If it remains on, repeat the process.
How do i reset the maintenance required light 2004 4runner?
Reset the light by following the procedure below: 1. Turn the ignition key to the "OFF" position. 2. Turn the ignition key to the "ON" position while holding down the trip meter reset button.
How do you turn off a2000 Honda accord maint required light?
With the ignition switch in the off position, press and hold the odometer reset button while at the same time turning the ignition to the on position. After a few seconds the maintenance required light will go out.
Why engine light not on?
"Check Engine" light comes on when you turn ignition switch on and should go off when engine cranks.
