it could be the odb-1 testor plug. that is the computer diagonistic plug. It is hard to say without seeing the engine compartment. hope it helps. duboff.
Are you sure of the engine size? Should be 7mge inline six cyl. 22r wasn't offered in a 1990 cressida.
I have a 1985 cressida with a good transmission but a blown engine sitting in my hard. I live in Pensacola, FL. Call me at 850 432 3011 or email me at imacountryboy@cox.net ken
What Cressida engine will fit to a Toyota pickup model19
Seek around the flywheel, The Flywheel is between engine and transmission. The starter is probably under the intake like the 7MGE.
how the sequence of spark plugs goes on the engine of 1990 Toyota cressida
Low pressure connector is at the front of engine below front exhaust manifold behind the electric fan for the rad....
To check OBD1 codes for a 1986 Toyota Cressida, first locate the diagnostic connector, which is typically found near the driver's side under the dashboard. Use a jumper wire to connect terminals TE1 and E1 on the connector. Turn the ignition to the "ON" position (do not start the engine), and the check engine light will blink the trouble codes in a sequence. Count the blinks to identify the codes, and refer to a service manual for their meanings.
On a 1987 Toyota Cressida, the starter is located on the driver's side of the engine compartment, near the bottom of the engine block. It is positioned just above the transmission and can be accessed from underneath the vehicle or from the top with some difficulty. To remove or replace it, you may need to disconnect the battery and remove a few components for better access.
Does the speedometer work? Sounds like the electrical connector from the transmission to the PCM is either not plugged in correctly or at all.
No, its fuel injected engine
If the check engine light is on for your 1991 Toyota Cressida, that makes that some repairs need to be made to the engine. Taking the car to a certified mechanic to perform a diagnostic test can confirm if there is any issues with the engine.
On a Toyota Cressida, the starter is typically located on the lower side of the engine, near the transmission. It is mounted to the engine block and can be accessed from underneath the vehicle. To reach it, you may need to remove any components obstructing access, such as the exhaust or heat shield, depending on the specific model year. Always ensure that the battery is disconnected before attempting any work on the starter.