answersLogoWhite

0

The blower resistor controls the speeds of the blower motor Hi-resistance lower motor speed Lo-resistance higher motor speed

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

On a 2006 Chevy silverado is the fan blower resistor attached to the outside of the fan blower housing or is it necessary to remove the housing to locate the resistor?

it is under the glove compartment on the passenger side of the truck


Where is the blower motor resistor located on 2006 Pontiac Grand Prix?

Resistor is located behind the blower motor assembly.


How do you replace blower resistor on a 2006 mustang?

# Locate the blower resistor under the right-side of the instrument panel # Disconnect the electrical connector from the blower motor resistor # Remove the blower motor resistor mounting screws and remove the resistor from the housing # Installation is the reverse of removal


Where is the heater blower resistor located on vauxhall zafira 2006 1.6 petrol?

They generally locate the heater motor speed resistor nearby the blower motor because the resistor depends on the blower to keep it cooled.


How do you replace blower motor resistor on 2006 Ford Freestar?

where is the location for a blower motor relay on a 2006 ford freestar


Where is the heater resistor coil located on a 2006 t300 kenworth?

The heater resistor coil is located on the blower motor on the 2006 T300 Kenworth.


Why does the blower fan only work on high in a 2006 Chrysler Sebring?

blower motor resistor needs to be replaced


Why does your fan only work on high in a 2006 Chrysler Sebring?

blower motor resistor


Heater blower motor has no power 2006 g6?

Blown Fuse, loose or disconnected wire, or defective blower motor resistor pack.


How do you remove blower motor resistor from a 2006 Mazda 3?

To remove the blower motor resistor from a 2006 Mazda 3, first, disconnect the negative battery cable to ensure safety. Then, locate the blower motor resistor, which is usually found near the blower motor under the passenger side dashboard. Remove any screws or clips securing it in place, disconnect the electrical connector, and then carefully pull the resistor out. Replace it with the new part, reattach the connector, and secure it back in place.


Is this a blower motor resistor problem or a blower moter you have a 2006 Nissan Xterra and it only blows on the 4 and not 123 does not blow ac on 4 only fan Thanks?

Blows on #4 only? I would replace the resistor. #4 speed by-passes the resistor.


How do you replace 06 Malibu blower motor resistor?

To replace the blower motor resistor in a 2006 Malibu, first disconnect the negative battery terminal to ensure safety. Next, locate the blower motor resistor, typically found near the blower motor under the dashboard on the passenger side. Remove the electrical connector and the screws securing the resistor, then take out the old resistor and install the new one in reverse order. Finally, reconnect the battery and test the blower motor to ensure it operates correctly.