it is under the glove compartment on the passenger side of the truck
Locate the resistor under the dash attached on the blower motor housing. Disconnect the wire harness connector. Remove the resistor and install a new one.
you have to remove the glovebox, its behind that, it has 2 bolts and a "connector", should be on the left side of the blower housing.
The blower motor resister is located just below the blower motor to the left attached to the housing.........
Under the hood on the passengers side near the blower motor attached to the housing......... I'm pretty sure that's where the "Relay" is located not "Resistor". The resistor may be located under or behind the glovebox.
How do your remove the lamp housing from a 2002 silverado driving lights? I can remove the upper head light housing but I can't get the driving light housing out.
follow your top radiator hose to the engine block. the hose will be attached to the thermostat housing. the housing is attached to the block with two bolts. remove the radiator hose from the housing, remove the two bolts, and gently separate the housing from the block. you will see the thermostat. The above answer is for a V6 engine. If your engine is a V8, follow the lower radiator hose toward the engine. The thermostat, housing & o-ring are one piece.
Resistor is located in the lower right side of the heater housing on manual a/c vehicles. Resistor is located in the lower right side of the heater housing on manual a/c vehicles.
Pull out the lock on the blower motor resistor wire harness connector to unlock the connector latch . Depress the latch on the blower motor resistor wire harness connector and disconnect the connector from the resistor. Remove the two screws that secure the blower motor resistor block to the HVAC housing. Remove the resistor block from the HVAC housing............
The blower unit is located i the passenger compartment above the right front footwell, ahead of the glovebox. The resistor is located in the housing just to the left of the blower housing.
Held in by two screws in a housing just to the left of the blower motor housing.
It is under the housing where the rad cap is attached.It is under the housing where the rad cap is attached.
The blower resistor is behind the glove box. It mounts to the HVAC housing.