Press it and the horn will beep a few times. It helps to locate your car.
how do you program a keyless remote for a 94 Dodge Intrepid. I battery died and now the horn keeps going off
Behind the left headlamp
inside the driverside wheelwell, toward the front of the car
you have to resync the remote after changing the battery, stand next to car hold the lock and unlock buttons down for about 7 seconds or until you hear the horn chirp, thats it good luckSource(s):Impala LS owner
Press the horn button. If you mean for the door locks, hold the info and arrow button down together. There you will see the setup submenu.
To program the keyless remote on a 1997 Jaguar XK8 to sound the horn when pressing the lock button, first, ensure the vehicle is in the "Run" position without starting the engine. Then, press and hold the "Lock" and "Unlock" buttons on the remote simultaneously for about 10 seconds until you hear a confirmation sound. This will enable the horn feature when locking the vehicle. If needed, consult the owner's manual for specific instructions or troubleshooting tips.
In a Chevy Cobalt, the horn relay is typically located in the under-hood fuse box. To find it, open the hood and look for the fuse box, which is usually near the battery. The relay is often labeled on the cover of the fuse box or in the owner's manual. If necessary, consult the manual for the exact location and diagram.
First unlock and open the hatch, the horn alarm is now disarmed and you can unlock the driver side door.
Have to go into body computer with DRB3 to disable horn honk when locking vehicle.
See FOB Light(Remote Visiual Verification) on page 2-48 and FOB Horn(Remote Audible Verification) on page 2-49 of your "Owner's Manual" for details & programming options.....
To program the keyless entry remote you hold down the lock and unlock keys at the same time while within 10ft of vehicle to make sure you are within range of the remote for approx 10 seconds. the vehicle will alert with a short horn sound. if it does not respond, repeat. should only take 1-3 tries before it's done
remove the drivers side headlight. then find the manufacturer horn under the headlight frame towards the front of the wheel well. there you go. u now have access to remove and check your horn.