0
What else can I help you with?
How do you get a thermostat unstuck on a 1996 dodge avenger?
replace it. when they go bad you can't fix them.
Where to buy thermostat housing for 1999 dodge avenger?
The dealership would be a good place to start.
What Temperature Degree Thermostat should you get for 2004 Dodge Ram 1500 4.7 liter?
For a 2004 Dodge Ram 1500 with a 4.7-liter engine, you should use a thermostat with a temperature rating of 180°F (82°C). This is the standard operating temperature for optimal engine performance and efficiency. Always ensure that the replacement thermostat is compatible with your specific engine model.
Where is the temperature sensor on a 2008 Dodge Avenger?
The temperature sensor on a 2008 Dodge Avenger is typically located near the thermostat housing, which is situated on the engine block. It is often found on the cylinder head or near the intake manifold, depending on the specific engine configuration. For accurate identification, consult the vehicle's service manual or a repair guide for detailed diagrams.
How do you change a thermostat on a 2008 dodge avenger and it also has two thermostats where are they located?
Changing a thermostat on a 2008 Dodge Avenger can be difficult because there area two thermostats. One is located under the intake manifold inside a housing unit, and the second is at the end of the radiator hose.
What temperature thermostat is in a dodge Dakota?
1992 dodge Dakota 5.2l 318....192 F thermostat
What temperature thermostat for a 1999 Dodge 3.9?
195
Where is the thermostat on the dodge avenger?
If you follow the bottom hose on your radiator it will lead you to it. You will have to remove 3 bolts on the thermostat housing to get to it but it should only take you about 20 minutes to change it out.
Where is the thermostat housing located on a 1997 V6 Dodge Avenger?
under the housing where the lower radiator hose hooks to the engine
When was Dodge Avenger created?
Dodge Avenger was created in 1995.
Where is the Intake Air Temperature for a Dodge Avenger?
It's located right on the intake tube.
How do you install a 2008 dodge avenger 2.7 thermostat?
To install a thermostat on a 2008 Dodge Avenger with a 2.7L engine, start by disconnecting the negative battery terminal. Drain the coolant and remove the upper radiator hose connected to the thermostat housing. Unbolt the thermostat housing, replace the old thermostat with the new one, ensuring the new gasket is in place, and then reassemble everything in reverse order. Finally, refill the coolant, reconnect the battery, and check for leaks.
