answersLogoWhite

0

The answer is winch

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

What is a wheel and axle with a free moving cord?

The answer is winch


What does Wheel and axle do?

There are two general forms: - a wheel attached to a fixed axle which rotates in a frame or mount - a wheel which has a hole in its center and revolves around an axle passing through it. In the first, lubrication can be applied to the mounting bracket where it holds the axle. In the second, lubrication is applied to the axle (shaft) where it passes through. This can also include ball bearings that distribute the weight and themselves roll within a mounting.


What type of simple machine are mini blinds?

Mini blinds are an example of a pulley system, which is a simple machine that uses a wheel and axle to lift or lower the blinds by pulling on a cord.


When was the first front wheel drive car produced?

The cord


Why is Fred barta in a wheel chair?

spinal cord stroke


What is Inflammation of the spinal cord called      ?

Inflammation of the spinal cord is called Myelitis.


Replace pull cord on 1990 15 hp mercury outboard?

take your cover off of the pull cord, there should be a slot in the wheel that turns your crank, take your cord and tie a knot at the end of it a slip it in the slot wind the cord around the wheel bolt cover back on go have some fun....


How long is a cord?

There is no unit of measure called a cord.


How do you remove front wheel on harley Davidson street bob?

1. Raise Motorcycle so front wheel is just raised off the ground. 2. Inspect wheel bearing end play and service bearings if necessary. 3. Remove brake caliper. Support caliper using a rubber bungee cord. NOTE Do not operate front brake lever with the front wheel removed or the caliper piston may be forced out of piston bore. Reseating the piston requires disassembly of the caliper. 4. Remove axle nut, lockwasher and washer. 5. Loosen the slider cap screws and pull the axle free. 6. Remove wheel from forks.


What is a simple machine made of a wheel and a cord called?

That would most likely be a pulley. A pulley is essentially a wheel on an axle that usually has a groove in the middle of its circumference that holds a rope, cable, belt, or chain. Pulleys are used to transmit motion rotationally and apply force in the direction of said motion. Two or more pulleys makes a tackle. Hope this is what you were looking for.


What is the cord called that makes your belly button?

Umbillical Cord


What is spinal cord therapy called?

Spinal cord therapy