0
Not sure which part you are looking at. There will be the brake line. If abs, there will be speed sensor wiring. There should also be a ground wire on the strut.
Not sure which part you are looking at. There will be the brake line. If abs, there will be speed sensor wiring. There should also be a ground wire on the strut.
What else can I help you with?
Where is the fuseable link for starting on a 2001 Chrysler PT cruiser?
The only fusible link is for the alternator. It is at the positive battery cable.
How do you adjust hand brakes?
Hand brakes are attached to the rear brakes in most vehicles. Start with making sure the rear brakes are in good working order and adjusted. Most vehicles will have a cable adjustment connected with the front cable that leads to the hand brake. Make this cable adjustment after the rear brakes have been inspected and adjusted.
How do you adjust a hand brake?
Hand brakes are attached to the rear brakes in most vehicles. Start with making sure the rear brakes are in good working order and adjusted. Most vehicles will have a cable adjustment connected with the front cable that leads to the hand brake. Make this cable adjustment after the rear brakes have been inspected and adjusted.
How can you put an automatic Chrysler PT Cruiser in neutral without the key?
You would need to take the shift cable off at the transmission and move the lever manually.
What are the best maintenance tips for beach cruiser brakes to ensure optimal performance and safety?
To maintain beach cruiser brakes for optimal performance and safety, regularly check and adjust brake pads, ensure proper cable tension, clean and lubricate brake components, and inspect for wear and tear. Additionally, test brakes before riding and replace any worn-out parts promptly.
How do you replace the battery in a 2001 or newer Chrysler PT Cruiser?
Remove air filter box.take o ff hold down clamp.remove cable terminals and lift out..
How do you locate the starter on a 1997 Chrysler lhs?
Under the drivers side of motor follow the red battery cable to where it is connected
HOW to change 1978 land cruiser emergency brake?
To change the emergency brake on a 1978 Land Cruiser, first ensure the vehicle is securely lifted and supported. Remove the rear wheels and brakes to access the drum or rotor, depending on your model. Disconnect the emergency brake cable from the lever and remove any retaining clips. Replace the old cable with a new one, reassemble the brakes and wheels, and adjust the tension to ensure proper function.
How do you adjust the emergency brake on a 2002 Honda CR-V?
The emergency brake cable is connected to the brake shoe on the rear brakes. You can adjust the emergency brake by loosening or tightening the nut on the end of the cable.
How does the handbrake function?
The hand break is attached to a cable, the cable pulls on a lever mounted in the rear brake and is directly connected to the brake shoes. this has the effect of bypassing the wheel cylinder and controlling the brakes directly.
How do you change cooling sensor on a 2004 Chrysler pt cruiser?
To change the cooling sensor on a 2004 Chrysler PT Cruiser, first, ensure the engine is cool and disconnect the negative battery cable. Locate the coolant temperature sensor on the engine block, usually near the thermostat housing. Unplug the electrical connector, unscrew the old sensor using a wrench, and replace it with the new sensor, making sure to tighten it securely. Finally, reconnect the electrical connector and the battery cable.
Is it possible to jump start a car with the positive cable connected first and the negative cable connected second"?
No, it is not possible to jump start a car with the positive cable connected first and the negative cable connected second. The correct order is to connect the positive cable first and then the negative cable.
