answersLogoWhite

0

This means that the system is too lean (bank 2). Check your PCV hose and elbows for wear or holes, and also using a flashlight, have a quick look at the IMRC to ensure that the bushings have not deteriorated and that the control arms have not detatched.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Where is evaporator 2004 Ford Freestar van?

inside the vehicle firewall


What car does Grandpa drive?

His red van was a 2002 or older Nissan Quest, and his beige is a 2007 or older Ford Freestar. The Freestar is no longer in production.


How many gallons of gas does a 2005 Ford Freestar van hold?

It holds 25 gallons


What car does angry grandpa drive?

His red van was a 2002 or older Nissan Quest, and his beige is a 2007 or older Ford Freestar. The Freestar is no longer in production.


Where is the inertia switch on 2004 Ford Freestar Van?

On a 2004 Ford Freestar : The fuel pump inertia switch is located in the cargo area behind the service panel cover on the passenger side of the vehicle


How do you find the coil pack on a 2004 Ford Freestar van?

there is no coil on 2004 freestar 3.9L engine. it is only an ignition module and it is located in the back of the engine by the firewall.


Ford windstar in production?

In 2004, Ford renamed the Windstar "Freestar", and also introduced a Mercury version of the mini-van, the "Monterey". Ford then made the decision to abandon the mini-van market after 2007.


Check emission system on a 2005 Ford Freestar Van after the emission light comes?

The computer system needs to be scanned to see what code is causing the light to come on. The code will tell you what sensors or other components that the computer thinks is bad.


Where do you find keyless entry code on 2004 Freestar van?

Each vehicle is provided with a default code that is normally in your owners manual that came with your vehicle. If you do not have this, you may need to contact a ford dealership to find out how to get the information you need to add or change your personal code entry.


Which gears on a Ford Freestar van should you lube using synthetic gear lube?

The best way to find out what gears to lube on a Ford Freestar is to start by looking in your manual. The manual has alot of important information. If it isn't there, visit the dealership.


How do you check emission system on a 2005 Ford Freestar Van after the emission light comes on?

See "Related Questions" below for the same discussion in the Windstar category - equally applies to the Freestar/Monterey


How to i access 1 spark plug in ford 4.2l Freestar van?

from the bottom ,behind the sub frame.for the three rear plugs.