0
Trouble code P0551 means:Power Steering pressure sensor circuit
range/performance
What else can I help you with?
What is the oil capacityof of a 2003 dodge neon sxt 2.0?
The oil capacity of a 2003 Dodge Neon SXT 2.0 is 4 Quarts of 10w-30 oil.
Where is the wire in a 2003 Dodge Neon SXT that makes it not start?
There are many wires on a Dodge Neon that can cause a no start condition.
How do you get rid of the governor in a 2003 Dodge Neon sxt?
Complete 420A/Neon MegaSquirt EMS Kit, will replace your Neon's computer and remove the governor
How many motor mounts fo r a 2003 dodge neon sxt?
it have 3 eng mount
What is the code p0508 on 2005 dodge neon sxt?
Trouble code P0508 means: Idle control system circuit low
P0073 error code for a 2003 dodge neon sxt I already replaced the map sensor and air inlet sensor and still the same code the code won't erase at all?
Try replacing the pig tail to the Air Inlet Sensor
How do you fix a P0344 code on a Dodge Neon 2003 SXT?
Disconnect your battery. Install a new camshaft sensor, then connect your battery back. I recommend genuine sensor (from dealer) or bwd brand.
What is the gas mileage for a 2003 Dodge Neon?
My 2003 Dodge Neon SXT, which is an automatic, gets 26.5 mpg. The gas mileage of any single 2003 Neon could be very different, as to whether its automatic or standard, SXT or something else, and even slight differences from car to car.
How many miles before you change a timing belt on a 2003 dodge neon sxt?
Every 100,000 miles is recommended.
Is the dodge neon a five speed?
I have 2003 Dodge neon sxt 2.0 liter and its a 4 speed and some are 3 speed I know this 4 sure about the 2003 If it has a manual transmission it would be a 5 speed.
What does sxt stand for on the dodge neon?
As far as an acronym goes, SXT doesn't stand for anything.
How do you change a thermostat on a 2003 dodge neon sxt?
To change the thermostat on a 2003 Dodge Neon SXT, first remove the drain plug to let the engine coolant drain into the pan. Unhook the coolant reservoir and remove the hose clamp. Spray the two thermostat housing mounting bolts with a solvent and pull out the old thermostat.
