answersLogoWhite

0

it is an oxygen sensor. located at before the catalytic converter to measure the amount of air fuel mixture. the term "lambda" is used since it uses a mathematical equation to determine this measure.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is lambda sensor located on clio 1995?

Lambda is o2 sensor in exhaust pipe.


Which gas component does a lambda sensor respond to?

The lambda sensor reads the oxygen in the exhaust stream.


Where is the lambda sensor located on a peugeot 306?

Year, engine?? Normaly lambda sensor is below exhaust collector


Where is the lambda sensor on a Kia Sportage?

The Lambda Sensor is situated in exhaust downpipe with connector rear of engine N/S.


Where is the lambda sensor located on a 1992 Jaguar xjs?

where is the right hand bank lambda sensor on a V12 1992 XJS


What kind of signal does the lambda sensor send?

oxygen sensor


What is lambda sound?

Lambda Sond is an Oxygen sensor which is very important to the fuel system.


Is a nox sensor the same as a lambda sensor?

A Nox sensor is very similar to a lambda probe, but its dedicated to measuring oxides of nitrogen in the exhaust gas. It looks pretty much the same and goes into the exhaust just like a lambda probe.


What is the Module on side of exhaust pipe?

Lambda Sensor.


Where is a lambda sensor often fitted?

down pipe


Vw golf 2000 1.4 base model. Where does the lambda sensor wire connect to. Is it the purge valve?

lambda sensor is also known as an O2 sensor should be on ur exhaust system hope that helps


How do you change lambda sensor Audi tt?

To change the lambda sensor on an Audi TT, first, ensure the engine is cool and disconnect the negative battery terminal for safety. Locate the lambda sensor, typically situated in the exhaust system; you may need to remove any heat shields for access. Disconnect the electrical connector and use a lambda sensor socket or wrench to unscrew the old sensor. Install the new sensor, reconnect the electrical plug, and reattach any removed components before reconnecting the battery.