0
What else can I help you with?
No heat dodge intrepid?
Check the coolant level. Check the thermostat.
Why doesnt heat work in 96 Dodge Intrepid?
could be a sticking thermostat.
What causes the heat not to work in a 1997 dodge Intrepid?
heating coil or fan
Why does Antifreeze leak when i run heat in my 2003 intrepid?
You probably have a leak in the heater core.
Why is your 1998 Dodge Intrepid leaking antifreeze and the heat is not working?
please dont say this question again
96 Dodge Intrepid keeps over heating?
Did you bleed the air valve? if you open any part of the cooling system on a dodge intrepid, ie: change the radiator hose or thermostat housing. You need to bleed the air out the Valve. If not the car will over heat.
No heat in 2003 Dodge Ram 1500?
There are a few reasons why there may not be any heat in a 2003 Dodge Ram 1500. Some of the reasons are a bad heater coil, blown fuses, or even a stuck thermostat.
What cause a Dodge Intrepid to blow cool air instead of heat?
IT COULD BE THE THERMOSTAT, THE VEHICLE BEING LOW ON COOLANT, OR A MODE DOOR WITHIN THE DASH
Where is the oil sending unit on a 2003 dodge stratus?
The oil sending unit on a 2003 Dodge Stratus is located on the side of the oil pan. It is under the heat shield.
The heat in my 96 Dodge Intrepid is not working but the fan does blow into the car it just won't heat up and the AC belt is not on it could that be interfering with my heat?
The thermostat may be stuck open, replace it. No ac belt won't effect the heater.
Why does a 99 Dodge Intrepid heat up when the ac is turned on?
If your car is anything like my 2001 intrepid, it is because only one of your radiator fans are coming on when the temp sensor tells your fans to turn on. You hear a fan kick on, but it is only one of them. There are two.
How do you change the oil pressure sensor in a 2003 dodge 2.7 liter engine?
they leak it is common.on the intrepid the sensor is on the passenger side half way up the block.unscrew it on the smaller sedan stratus etc.it is buried in the back under a small heat shield hard to do unless on a lift
