The air gap between frictional surfaces of the clutch plate and clutch rotor should be 0.40-0.50mm (0.015-0.020").
In most ac clutches .015" works fine.
For a 1996 Chevy Cheyenne, the gap setting between the clutch plate and the pulley assembly of the air compressor is typically around 0.020 to 0.030 inches. This gap ensures proper engagement and disengagement of the clutch for efficient operation. It's essential to check the vehicle’s service manual for specific tolerances and adjustments, as variations may occur based on the specific compressor model used.
30 thousands........
.18
.010" to .015" works. Recheck after the new clutch has burnished.
The air gap for the AC clutch on a 1994 Toyota Corolla is typically around 0.020 to 0.030 inches (0.5 to 0.76 mm). This gap ensures proper engagement and disengagement of the clutch when the air conditioning system is activated. It's important to measure this gap accurately for optimal performance and to prevent premature wear. Adjustments can be made by adding or removing shims if necessary.
The 2146 does not have an adjustable clutch, some other models do.
1993 Chevy cavalier 2.2l Spark gap is....................... 1.4mm
go to 99intrigue.shutterfly.com/compressor. Get clutch remover and installer. Get feeler gauge. Remove serpentine belt with 1/2" breaker bar. Measure air gap in clutch. Remove shaft nut. Remove clutch with remover. Remove outer snap ring. Remove pulley with pry bars or remover. Remove clutch coil with pry bars or remover. Replace new coil and pulley. Replace snap ring. Replace clutch, maintaining air gap. Reinstall nut. Reinstall belt.
gap is .035
.43 is the gap
This requires special tools to remove and install the ac clutch and bearing. The air gap on the ac clutch must be done during install.